User manual ECLIPSE TD725SW

[. . . ] If water or foreign matter gets inside the subwoofer, it could lead to fire or electric shock. Do not use any power cable other than the one supplied with the product. Do not damage the power cable, bend it excessively, twist it, modify it, or rest the subwoofer on it. Note also that resting heavy objects on the power cable, subjecting it to heat or pulling on it could break the cable, leading to fire or electric shock. [. . . ] If you move the subwoofer with the cables connected, a cable could be damaged, leading to fire or electric shock. The subwoofer is heavy and must be unpacked and carried by at least two people, otherwise injuries could result. Note also that there are some sharp angles in the construction of the subwoofer and it must therefore be handled with due care. Before cleaning/caring for the product, be sure to switch off the power supply and remove the power cable plug from the power outlet. If you do not use the subwoofer for a long time, for example when you are on vacation, for the sake of safety always switch off the power supply and remove the power cable plug from the power outlet. Before connecting a TV or any other audio device, be sure to switch off the power supply, carefully read the instruction manuals of the devices involved, and make the connections in accordance with the directions in these manuals. Before turning on the power, make sure that the volumes of the subwoofer and the amplifier are set to minimum. Otherwise a very loud noise could suddenly be generated, causing hearing impairment or other problems. If you hear an abnormal sound while the audio equipment is operating at a high volume, turn the volume down. If you continue to use the subwoofer at the high volume, or use it for a long time while it is producing distorted sound, the speaker will heat up, and this could lead to fire. ENGLISH - 19 - Precautions on Use Before turning the power on, and before switching inputs, always set the volume to minimum. Depending on the location, your enjoyment of music could annoy other people. Please set the volume to a suitable level so as not to disturb the neighbors. Please respect each other's concerns so as to maintain a comfortable living environment. Make sure that the power to all devices is off before connecting the subwoofer. If the subwoofer becomes soiled, wipe it lightly with a soft cloth moistened with a neutral detergent. Do not use thinners or benzene. ENGLISH Installing the Main Unit Fitting the feet Indicator panel Subwoofer When the subwoofer is installed directly on flooring or a similar surface, fit the feet to the bottom of the subwoofer. CAUTION Foot x 4 To avoid damaging the speaker or the floor, spread a soft cloth or something similar on the floor and do the work on this cloth. Placing the unit The subwoofer has a photoreceptor for the remote control on the indicator panel and the indicator panel on the unit must be oriented toward the audience. If the subwoofer is oriented parallel to the walls of the room, sound reflected from the walls may cancel out some of the sound it produces, so you are recommended to orient the subwoofer at an angle to the walls. Advice Do not install the subwoofer at a location where the remote control photoreceptor is exposed to direct sunlight or any other strong light. This may cause failure to respond to remote controller operations, or erroneous operation. - 20 - Names and Functions of Parts Main Unit q w ert y ENGLISH !00 + + + - - + u io !1 !2 qVolume control This is a knob for adjusting the volume. control This is a knob for adjusting (cutting) the highrange frequencies. The range in which adjustment is possible is 40 Hz to 200 Hz. eL. P. F. [. . . ] of 1%) Total high frequency distortion factor : 0. 05% (at 50 Hz and half the rated output) Playing frequency characteristics : 20 Hz ­ 200 Hz (BASS MODE, L. 200Hz) Input sensitivity: 40 mVrms (50 Hz) Signal to noise ratio : 95 dB or higher ENGLISH Gasoline Thinner If the subwoofer operates abnormally If, during use, the subwoofer is subjected to strong external noise (abnormal power supply voltage caused by excessive impact, static electricity, or a lightning strike), or it is handled incorrectly, it may stop operating correctly. If the fault remains, please contact Fujitsu Ten. Input impedance : 10 k ohms External dimensions : W517 x H473 x D503 (mm) [W201/4" x H185/8" x D193/4"] (including projections) W473 x H473 x D473 (mm) [W183/4" x H183/4" x D183/4"] (dimensions of the box) Input voltage : 100 V (Japan) 120 V (USA) 230 V (Europe) Power consumption : 65 W Speaker opening diameter : 10" x 2] 25 cm x 2 Weight : Approx. 42. 5 kg [931/2 lbs] - 27 - Warranty (appended) Read the warranty carefully and then keep it in a safe place. [. . . ]