User manual ECLIPSE ECLIPSE TD BROCHURE

[. . . ] Please read and understand the warnings before continuing with the rest of this manual. WARNING CAUTION These warnings represent occasions where improper use of the product may result in death or serious injury. These cautions represent occasions where improper use of the product may result in serious injury or damage to the product. WARNING Do not place the unit in an elevated location. For internal inspection, repair or maintenance, please contact a Customer Service Center. [. . . ] Do not place above or near the unit, any flower vases, plant pots, cups, makeup, medicine or any vessel containing liquid or any small metal objects. In case any liquid or small metal objects enter the unit, fire or electric shock may result. Do not push or drop any metal or combustible objects into the ventilation holes of this unit. (Be particularly cautious in households with young children). CAUTION Do not use the stand to support any other item. The mounting may become unstable, resulting in a fall, causing injury. Placing the unit on an unstable surface may cause it to fall over and cause injury. The unit is heavy so always use two people to unpack and carry the unit. Back pain and injury to feet may result if the unit is dropped. Notes on Use Before turning the unit on or changing the input source, be sure to set the volume to Low. You must use the attached hexagonal socket head bolts (x 3) to fasten the speaker. The washers must be used with the convex side facing down. Feet adjustment As shown in the diagram, turn the feet to adjust. ADVICE Feet Initially, turn the four feet in an anti-clockwise direction as far as they will go and place the unit on the floor. Then, turn each foot individually in a clockwise direction until they touch the bottom foot ­ then stop. 3 Setting the angle adjustment screw at 0 degrees Template Angle adjustment screw ADVICE When adjusting the speaker angle, follow these instructions and start from a 0 degrees position. Template 4 Adjusting the speaker angle Using the hexagonal wrench, loosen the hexagonal socket head bolts (3 places). When finished, use the hexagonal wrench to tighten the hexagonal socket head bolts. To secure the speaker, first tighten the two rear bolts, then tighten the front bolt. Upward adjustment Hexagonal wrench ADVICE When the top surface of the stand and the bottom surface of the speaker are flush, they should be level. It is possible to adjust the speaker upwards by 10 degrees. Angle adjustment screw 5 Installation of protective cover. As shown in the diagram, install the protective cover. ADVICE The protective cover may be attached when the speaker is not in use or at the user s discretion. Maintenance / Specifications Maintenance Before maintaining the unit, ensure that the power is off and the power cord removed. If it is particularly dirty, use a slightly damp cloth to wipe it down, then use a dry cloth. on this unit as it may damage the cabinet. Specifications Specifications and appearance are subject to change without prior notification. [. . . ] ·oe TD712z Diameter: Type: Input Resistance: Impedance: Dimensions: Weight: 12cm Bass ref/box Rated 35W / Maximum 70W 6 347mm(W)x384mm(D)x988mm(H) 32kg Gasoline Thinner Problems during Operation of the Unit During operation, the unit may stop working properly if it suffers from significant external disruption (impact shock, static electricity, voltage fluctuation caused by lightning, etc. ) or is operated incorrectly. In this situation, turn the amplifier power to switch to the "Off" position. (If a problem persists, please contact our Service Centre) Warranty and After-Service Warranty Certificate (included) After reading the contents of the Warranty Certificate, put it away in a safe place. [. . . ]