User manual EATON ELLIPSE PRO 850 FR

[. . . ] €  he battery must be disposed of in accordance with applicable regulations. To remove the battery, shut down the T UPS (button 6 OFF), remove the power cord and proceed as indicated below "Battery change". Battery change 650 / 850 b e a c d •  arning: take care not to inverse the polarity + (red) and - (black) when connecting the battery as this will destroy W the device. [. . . ] Connect the existing device cable between the wall outlet and the UPS, and use a similar cable between the UPS and the device, as indicated in figure C (cable not supplied). Optional USB connection: The UPS device can be connected to the computer using the USB cable 5 supplied (see figure C). The software is available on the CD-ROM 5 or Eaton UPS Companion software is downloadable from powerquality. Master and EcoControl outlets operating procedure In order to limit energy consumption of peripherals (scanner, printer) in standby mode, the Ellipse PRO is equipped with EcoControl outlets that are dependent on the Master outlet. When the main device supplied by the Master outlet (computer) is shut down, the EcoControl outlets are automatically deactivated and the peripherals shut down. This function (deactivated by default) is validated and configured using the configuration tool integrated in the software. Note: when the function is activated, do not connect critical applications to EcoControl outlets. Threshold setup A default setup ensures the correct operation of the EcoControl function. However, depending on the consumption of the main load, the trigger threshold of the EcoControl function may have to be modified using the configuration software supplied with the UPS: •  irst, make sure that the function is activated in the "EcoControl Function" tab of the F configuration tool. € f the peripherals connected to the EcoControl outlets do not switch off when the main I load is not in normal operation (ex: when in standby mode), the detection threshold value must be set to High. € f the rated consumption level of the main load is low and the EcoControl outlets shut I down when the main load is operating normally, the detection threshold value must be set to Low. UPS setting through the LCD English Release scroll down button to select menu 5s 2s 2s 2s 2s Output voltage Input voltage tolerance EcoControl Alarm (165 - 264 V) (150 - 284 V) Example of setting 10s Save the new value 5s 5s l LCD shut off if no activity for 3 minutes. Operation Battery charge The UPS charges the battery as soon as it is connected to the AC outlet, whether button 6 is pressed or not. When used for the first time, the battery will only provide its maximum performance after it has been charged for 8 hours. It is recommended that the UPS be permanently connected to the AC power supply to ensure the best possible performance. Surge protection outlets 18 without battery backup Equipment connected to these outlets is supplied as soon as the AC cord 4 is plugged in. Battery backup outlets 19 Equipment connected to these outlets is supplied as soon as button 6 turns green (see figure D). These outlets can be turned on even if the UPS is not connected to AC power (button 6 flashes). [. . . ] € EcoControl outlets keep powered when main application (Master outlet) is stopped. € Activate or set properly EcoControl function using the software provided with the product. €  e a duração do corte da rede eléctrica for superior à autonomia da bateria, a S UPS pára e recomeça a funcionar automaticamente quando a rede eléctrica for restabelecida. [. . . ]