User manual EATON 3S 700 FR

[. . . ] 5 mA 10 A resettable circuit breaker 5 ms typical Tel, ISDN, ADSL, Ethernet 12 V, 5 Ah Once a week 4 years typical, depending on number of discharge cycles and temperature 0 to 40 °C -25 °C to +55 °C 0 to 85 % 0 to 2000 m IEC 62040-1, CE certified IEC 62040-2 2 years 335 x 140 x 86 2. 1 A max l Voltage/frequency l Total of battery backup outlets 6 in battery mode output current for all outlets current of battery backup outlets 6 current time surge protection battery test temperature relative humidity elevation compatibility standards l Output l Leakage l Input protection l Transfer l Telephone l Sealed lead-acid battery battery life temperature l Automatic l Average l Operating l Storage l Operating l Operating l Safety standards l Electromagnetic l Warranty l Dimensions l Weigth (mm) (Kg) (*) Warning: EATON 3S is a class C2-UPS product. In a domestic environment, these products may cause radio interference, in which case, the user may be required to take additional measures. [. . . ] In normal mode, the audio alarm beeps every five seconds, then every two seconds when the end of battery backup time is near. L If the power outage lasts longer than the battery backup time, the UPS shuts down and automatically restarts when power is restored. Following a complete discharge, a few hours are required to recharge the battery back to full backup time. L To save battery power, it is possible to press button 8 to cut the supply of power to the devices connected to the battery backup outlets. L Lightning protection: All outlets, whether backed up or simply filtered, include surge protection, whatever the position of button 8 . L Shutdown of the battery backup outlets 6 : Press button 8 for more than two seconds. Battery service life is reduced by 50 % for every ten degrees above 25 °C. L The battery elements must be replaced exclusively by qualified personnel (risk of electrocution), with new elements approved by EATON to ensure correct operation of the UPS. L The battery must be disposed of in accordance with applicable regulations. To remove the battery elements, shut down the UPS (button 8 OFF), remove the power cord and proceed as indicated in page 4 "Battery change". L Battery charge: The UPS charges the battery as soon as it is connected to the AC outlet, whether button 8 is pressed or not. When used for the first time, the battery will only provide its maximum autonomy after it has been charged for 8 hours. It is recommended that the UPS be permanently connected to the AC power supply to ensure the best possible autonomy. L Filtered outlets 5 without battery backup: Equipment connected to these outlets is supplied as soon as the AC cord is plugged in. L Battery backup outlets 6 : Equipment connected to these outlets is supplied as soon as button 8 turns green (see figure E). These outlets can be turned on even if the UPS is not connected to AC power (button 8 flashes). [. . . ] 614-09954-00 7 English The battery backup outlets 6 are not supplied with power. L Se a duração do corte da rede eléctrica for superior à autonomia da bateria, a UPS pára e recomeça a funcionar automaticamente quando a rede eléctrica for restabelecida. UPS anslutningar Anslut UPS:en 1 till växelspänning via vägguttag med skyddsjord och den medföljande kabeln för UPS med FR/DIN-kontakter eller med anslutningskabeln till er dator för UPS med IEC-kontakter (se bild A). [. . . ]