User manual EAGLE ACCESS CONTROL SYSTEMS POWER II

[. . . ] INSTALLATION & OWNER'S MANUAL THE EAGLE POWER II BATTERY BACK UP Control Box Battery Box PHONE (818) 764-6690 / TOLL FREE (800) 708-8848 PRE INSTALLATION INSTRUCTIONS ! CAUTION! BEFORE PROCEEDING WITH INSTALLATION READ THIS MANUAL THOROUGHLY AND CAREFULLY FOLLOW ALL THE OPERATION INSTRUCTIONS. ! CAUTION THE POWER II IS INTENDED FOR USE WITH ONE 1HP GATE OPERATOR. [. . . ] The connector labeled "AC In" is connected to the main AC supply. Connect the incoming AC line to the AC In as follows: L - AC Line In (Live): Black N - AC neutral (Common): White G - AC Ground (Earth): Green Connect the outgoing AC line to the AC Out as follows: L - AC Line Out: Black N - AC neutral: White G - AC Ground: Green Refer to the installation manual provided with operator for the proper connections to the operator APPLYING THE POWER AND CONNECTING THE SYSTEM RELAY With the power to the operator and breaker box turned off and all of the AC line connections are complete, install the provided relay. When testing is completed, turn on the breaker and the green inverter light will go off, then the charger green or yellow light will go on. FOR HOLD OPEN APPLICATION Connect the two orange wires from the sub panel to the "exit open" on the operator. Using this connection will immediatly open the gate upon power failure. The operator will resume normal operation when power is resumed. REMINDER: There is a time delay of approximately 1-3 seconds between a power failure and the initial functioning of the Power II. Eagle recommends surge protection be installed on the incoming 110 AC Line to the battery back-up unit. IMPORTANT! (4) INSIDE OF THE EAGLE POWER II Control Box Battery Charger + 2000 Watt Inverter - Control Sub Panel AC OUT Hold Open AC IN Battery Terminals Battery Box - + 70 Ah Battery (5) MOUNTING THE EAGLE POWER PS INSTALLATION OF THE E-I I 21" Mounting Bracket Holes 3/8" Diameter 13 3/8" Rear View of Control Box 10" OC 1" 18 1/2" 20" OC Drawings Not To Scale 16" 2 1/2" Mounting Bracket Holes 3/8" Diameter 12 1/2" 7 1/2" OC Rear View of Battery Box 2 1/2" 13 3/4" 14 1/2" OC (6) THE EAGLE POWER II Recommended Installation with flex conduit Control Box Battery Box 3/4" Water-tight flexible conduit with fittings (7) S P E C IF IC AT IONS & WAR R ANT Y T E C HNIC AL S P E C IF IC AT IONS INP UT V OLTAG E : B AT T E R Y: R E C HAR G E T IME : OUT P UT V OLTAG E : OUT P UT F R E QUE NC Y: OUT P UT C UR R E NT: S UR G E C UR R E NT: AC OUT P UT P OWE R : S UR G E P OWE R : R E LAY OUT P UT S : 105 - 125 VAC 12V DC / 70AH 8 HOUR S 115 VAC 60 Hz 15 AMP S 3 0 AMP S 2000 WAT T S 4000 WAT T S 10 AMP S ! C A UT ION! DO NOT E XC E E D T HE OUT P UT C APAC IT Y OF T HE P OWE R II. C ONNE C T ING A MOTOR LOAD LAR G E R T HAN R E C OMME NDE D MAY DAMAG E T HE P OWE R II AND V OID T HE WAR R ANT Y. MA NUFA C T UR E R 'S L IMIT E D WA R R A NT Y E agle Acces s C ontrol S ys tems , Inc. warrants its P ower II to be free from defect in material and workmans hip for a period of one(1) year from the date of purchas e for s ingle family home or multi-family and commercial us e. To obtain s ervice under this warranty the buyer mus t obtain authorization ins tructions for the return of any goods from E agle before returning the goods . [. . . ] No pers on is authorized to as s ume for E agle any other liability in connection with the s ale of this product. F or F urther Information: P hone (800) 708-8848 / F ax (818) 764-6869 (8) [. . . ]