User manual E-Z WAY PRODUCTS RBX-60

[. . . ] 2 Côtés/dessus/dessous: Assurez-vous que rien ne bloque les espaces indiqués sur le schéma ci-dessous. 3 Dessous: Posez l’appareil sur une surface plane et horizontale. Veillez à ce que sa ventilation correcte puisse se faire en le plaçant sur un support d’au moins dix centimètres de hauteur. ABOUT DISC/FILE/iPod/DISPLAY Playable discs/files Discs CDs with one of the marks below on the surface. • The reflection factor of CD-RW is lower than that of other CDs, possibly causing CD-RW to take longer time to read. [. . . ] \ Playing order is determined when the groups and tracks were recorded. In this case, disconnect and connect the USB device again after turning off the unit. Disc player CD capacity: Signal-to-noise ratio: Dynamic range: Tuner FM tuning range: Antenna: General Speakers: • Full range: Power supply: 1CD 85 dB 90 dB 87. 5 MHz – 108. 0 MHz FM telescopic antenna Power consumption: AC 120 V , 60 Hz DC 15 V (R20 (SUM-1)/D (13D)-size batteries x 10) External DC 12 V (Car battery via the optional car adapter) AC 120 V , 60 Hz: 28 W (at operation) 1 W (on standby) External DC 12 V 2 A (power on mode) 666 mm (26 1/4”) x 231 mm (9 1/8”) x 240 mm (9 1/2”) (W/H/D) Approx. 6. 8 kg (15. 0 lbs) (without batteries stored in the battery compartment) Power cord x 1 Remote control x 1 Shoulder belt x 1 Buckle x 2 Stopper x 2 Car adapter (not supplied) Battery compartment To car’s cigarette lighter socket (DC12V) Battery compartment NOTE • The power can also be supplied through the batteries (see the instruction on the right) and the car battery (see below). • A small amount of power is always consumed even while on standby. CAUTION • Only use E-Z WAY PRODUCTS power cord provided for this unit to avoid malfunction or damage to the unit. • Remove all the batteries when using the power cord or car battery. • Be sure to unplug the power cord from the outlet when going out or when the unit is not in use for an extended period of time. Cautions when connecting to the car adapter • Be sure to use the car adapter (not supplied) with the same polarity design as the one equipped with this unit to prevent mishaps or damage. • Be sure to start the engine when you use the car adapter; otherwise, the car battery will be exhausted. • To prevent malfunctions, do not leave the unit in a car for a long time. Unplug the AC power cord from the unit to supply the power through the car battery or batteries in the battery compartment; otherwise, the unit does not work. • When you selected another source press iPod 6 again to start playback. Main unit Remote control iPod menu operation (Remote control only) 1 Press MENU to display the menu. Main unit Remote control Remote control Dock adapter (supplied with iPod or sold separately) Front door 2 Press GROUP UP or GROUP DOWN to select a menu item, then press SET to confirm it. To pause, press CD 6 or USB 6. Main unit Remote control To detach the dock adapter Pull up the dock adapter with your fingernail or sharp pointed tool using the slot. • Be careful not to injure your fingertips or damage the terminal of the dock. To fast forward/reverse, press and hold 4 or ¢ during playback. To go back to the previous menu, press MENU. Refer also to the instruction manual for iPod for details. Start Playback 1. Main unit Main unit Remote control • Press and hold 4 or ¢ to change the frequency automatically until a station of sufficient signal strength is tuned in. Presetting stations (Remote control only) You can preset 30 FM stations manually. • Finish the following steps while the indication on the display is flashing. To listen to the preset stations, press number buttons to select the preset number. Turning off iPod Press and hold iPod 6 for about 2 seconds. • Turning off the unit may not turn off iPod depending on the current source. Remote control Start Playback 1. [. . . ] To cancel the sleep timer, press SLEEP repeatedly to select “OFF. ” Adjusting the super woofer volume You can adjust the volume level between 1 and 6. Main unit Remote control • When you press and hold the button, the hour digit changes continuously. • When you press and hold the button, the minute digit changes continuously. Finish setting the clock. The minutes digits start flashing on the display. [. . . ]