Detailed instructions for use are in the User's Guide.
[. . . ] Most queries can be solved over the phone by one of our trained Helpline staff. If your machine needs attention, we'll aim to send one of our Dyson engineers to fix it within 3 working days. We won't keep you waiting around either; our engineers can visit a home or work address wherever is most convenient for you.
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER When using an electrical appliance, basic precautions should always be followed, including the following: 1 2 3 4 5 6 7 This machine is for domestic use only. If the supply cable is damaged, it must be replaced by Dyson Ltd, our service agent or similarly qualified persons in order to avoid a hazard. [. . . ] Check to ensure your electricity supply corresponds to that shown on the rating plate. Do not lubricate any parts, or carry out any maintenance or repair work other than that shown in this manual, or as advised by the Dyson Helpline.
Ensure you register for your 5 year guarantee today.
8 9 10 11 12 13 14 15 16 17 18 19 20
ONLINE
Just visit www. dyson. com/register
PHONE
7 days a week UK 0800 279 5127 IRL 01 475 7109
21 22 23 24 25
MAIL
Complete and return the free post registration form
Note your serial number for future reference
Do not pull on the cable.
Do not store near heat sources.
Do not use near naked flame.
Do not run over the cable.
Do not pick up water or liquids.
Do not pick up burning objects.
Do not use above you on the stairs.
Do not put hands near the brushbar when the cleaner is in use.
Using your Dyson
Hard floors or carpets
High-reach cleaning
clik
OFF
ON/OFF ON
Clear bin emptying
TM
2
clik
1
clik
Looking for blockages
Clearing brushbar obstructions
IMPORTANT!
WASH FILTERS
Filter A
1
Wash filters with cold water at least every month.
11 12 1 10 9 8 7 6 5 2
24
3 4
Filter B
10x
11 12 1 10 9 8 7 6 5 2
24
3 4
Turn over and tap very firmly to remove motor emissions. Repeat 10x or until water runs clear.
THIS APPLIANCE IS INTENDED FOR NORMAL DOMESTIC USE ONLY
SAVE THESE INSTRUCTIONS
Assembly
Lie machine flat and push on cleaner head until it clicks. Stand vacuum up straight, insert wand into hose and push into place until it clicks. Attach tool to the side of the machine.
Cleaning the Clear binTM
Caution: (i) (ii) (i) (ii) (iii) Do not immerse the whole cyclone in water or pour water into the cyclones. When vacuuming, certain carpets may generate small static charges in the clear binTM. These are entirely harmless and are not associated with the mains supply. To minimise any effect from this, do not put your hand or insert any object into the clear binTM unless you have first emptied it and rinsed it out with cold water.
THIS APPLIANCE IS INTENDED FOR NORMAL DOMESTIC USE ONLY
SAVE THESE INSTRUCTIONS
Using your Dyson
Press foot pedal and recline handle to use. When finished cleaning, push machine into an upright position and stabiliser wheels will automatically drop. Caution: (i) (ii) When returning to the upright position, ensure that the stabiliser wheels are fully engaged before releasing the cleaner. Do not press the cyclone release button while carrying the machine or it could fall and cause injury. Fine dust such as plaster or flour should only be vacuumed in very small amounts. Consult your flooring manufacturer's recommended instructions before vacuuming and caring for your flooring, rugs and carpets. If this is the case, we recommend vacuuming in hard floors mode and consulting with your flooring manufacturer. (See `Hard floors or carpets' section. ) If used in a garage for car cleaning, care should be taken to wipe the soleplate and wheels with a dry cloth after vacuuming to clean off any sand, dirt, or pebbles which could damage delicate floors.
Please note:
Please note: (i) (ii)
Washing your filters
Caution: (i) Switch `OFF' before removing the filters. It is important to check your filters regularly and wash at least every month according to instructions, to maintain performance. The filter in the ball should be rinsed and tapped out until the water runs clean, then tapped out again to ensure all excess water is removed. Please note: (i) (ii) (iii) It is normal for the filter in the ball to turn grey in colour. Do not put the filters in the dishwasher, washing machine, tumble dryer, oven, microwave or near an open flame.
(iii)
Hard floors or carpets
The brushbar will always default to `ON' (spinning) each time you switch on the machine and recline it for cleaning. If the brushbar stops during use, please refer to the `Clearing brushbar obstructions' section. [. . . ] If this happens you will need to remove brushbar as shown and clear any obstructing debris.
Conformity information: A sample of this product has been tested and found to conform with the following European Directives: 2006/95/EC Low voltage Directive, 2004/108/EC EMC Directive, 93/68/EEC CE Marking Directive. Product information: Net weight 5. 2kg, 230-240V, 50Hz, maximum power 650W. This product is protected by the following intellectual property rights: Patent/Patent Application numbers: JP 2004-537336; EP 1361812; AU 744408; EP1119282; JP 2002-527132; US 6, 519, 807; AU 744362; EP 1121043; JP 2002-527131; US 6, 572, 078; GB 0326102. 1; AU 2002-226556; EP 1370172; JP 2004-528876; US 6, 991, 666; AU 2002-225207; EP 1361814; JP 2004-520137; US 7, 018, 439; AU 2001-240894; EP 1268076; JP 2003-528704; US 6, 835, 222; AU 2002-225232; EP 1361815; JP 3940082; US 6, 974, 488; AU 2003-283157; EP 1526796; JP 2006-503607; US 2005-0235454; AU 2003-283159; EP 1526797; JP 2005-534442; AU 2003-283161; EP 1526798; JP 2006-503608; AU 2004-294771; EP 1680232; JP 2007-508934; US 2007-0079579; AU 2005-263889; EP 1768536 Equivalent patents, registered designs and applications exist in other countries. Please note: Small details may vary from those shown.
IMPORTANT!
WASH FILTERS
1
GB Dyson Customer care
Wash filters with cold water at least every month.
service@dyson. co. uk 0800 279 5127
Dyson Ltd, Tetbury Hill, Malmesbury, Wiltshire SN16 0RP
IRL Dyson Customer care
irelandservice@dyson. com 01 475 7109
The Connect Agency Ltd, Unit 2, Baldonnell Business Park, Naas Road, Co. [. . . ]