User manual DYSON DC02 ABSOLUTE

[. . . ] To unlock and resume full suction, press down the opposite end of the trigger. Sits securely on the stairs However, always work above the machine on stairs for your own safety. Telescopic wand click 3 Press yellow button and slide wand down to adjust length. Blockage procedure Please note: Any ‘Blockage only’ repairs will incur a charge of $60. 00 *. Check filters, replacing S-level if older than 3 months and HEPA if older than 12 months, or if filters are heavily coated with dust. *Price correct at time of printing. 1 To empty clear bin, pull back release catch under carrying handle and raise top of machine. 1 2 Lift clear bin out of machine. 1 1. Check entry swivel ∂ by pressing yellow buttons & pulling out hose. Clear any debris. 3 Remove cyclone top (lid). 1 The plug is situated underneath the tool cover on the right hand side. 1. [. . . ] Call or fax the Helpline for orders. IMPORTANT: Use only genuine Dyson filters, which have been tested and approved for this cleaner. The Dyson DC02 has a built-in thermal cut-out to protect your vacuum NOTE cleaner in the event of a restriction to the airflow. Having established that there are no blockages and that the filters have been replaced within the stated time, leave your vacuum cleaner detailed in for operating and then try using again. Having established that there are no blockages and that the filters have been replaced within the stated time, leave your vacuum cleaner unplugged for 60 minutes and then try using it again. If the vacuum cleaner still does not work, please call Dyson If the vacuum cleaner 827272. ) Customer Care (Tel: 01666still does not work, please call Dyson Customer Care (Tel: 1800 239 766). Your Dyson has a built-in the vacuum cleaner from the wall the IMPORTANT: Always unplug thermal cut-out to protect it in event of a restriction to the airflow and may suddenly stop socket before inspecting it. working temporarily if you do not change the filters at the If the vacuum cleaner suddenly stops working (ie. the motor makes no sound stated time, or if blockages are not cleared immediately. when switched on) then please check your DC02 for blockages as detailed If the vacuum cleaner suddenly stopsalso to check the fuse in the plug). the motor makes no sound when switched on) then please check your cleaner for blockages as Important safety instructions – please read before use WHEN USING THE DYSON DCO2 VACUUM CLEANER PLEASE ADHERE TO THESE SIMPLE PRECAUTIONS. B Y D O I N G S O Y O U W I L L R E D U C E T H E R I S K O F F I R E , E L E C T R I C A L S H O C K O R I N J U R Y. 1. Do not leave your Dyson cleaner with the plug connected to a mains outlet – unplug when not in use. Turn the cleaner off with the switch button before removing from the mains outlet. Always remove the plug from a mains outlet before carrying out any maintenance. Do not carry out any maintenance work on the cleaner other than that outlined in this manual, especially where electrical components are concerned. Do not use without the clear bin assembly fitted correctly and both filters in place. Do not fit anything other than Dyson spare parts (available on the Helpline on 1800 239 766). Do not continue to use the cleaner if any part appears to be faulty, missing or damaged. Do not put any part of the body, clothes or any object near or into the openings or moving parts of the machine. Do not use the machine with any of the openings blocked with any object that may restrict the airflow. Do not pull on the supply cord, run over it or pull it around sharp edges or near/over hot surfaces. Do not use the cleaner if the cord or plug are damaged or if the cleaner has been damaged, dropped or has come into contact with water or any other liquid. Electrical shocks could occur if used outdoors or on wet surfaces. IMPORTANT A LWAY S U N P L U G T H E VAC U U M C L E A N E R F R O M T H E WA L L S O C K E T B E F O R E I N S P E C T I N G I T NOTE Check that your supply corresponds to that shown on the rating plate. [. . . ] If the supply cord of the appliance is damaged, disconnect the appliance from the socket outlet immediately. or their appointed agent as special purpose tools and service techniques are required. 9. 3. 10. Do not use the cleaner to pick up flammable or combustible substances or hot ashes or burning objects of any kind. Static charge can occur in many ways and, when vacuuming, certain carpets may generate small static charges in the clear bin. [. . . ]