User manual DYSON AB12

[. . . ] If the supply cord is damaged it must be replaced by Dyson, its service agent or similarly qualified persons in order to avoid a hazard. If the appliance is not working as it should, has received a sharp blow, has been dropped, damaged, left outdoors, or dropped into water, do not use and contact the Dyson Helpline. Do not disassemble the appliance as incorrect reassembly may result in an electric shock or fire. Do not close a door on the cord, or pull the cord around sharp edges or corners. [. . . ] Accidental damage, faults caused by negligent use or care, misuse, neglect, careless operation or handling of the appliance which is not in accordance with the Dyson Operating Manual. Use of the appliance other than for normal domestic purposes within the country of purchase, e. Use of parts and accessories other than those produced or recommended by Dyson Canada Limited. Blockages – please refer to the Dyson Operating Manual for details of how to look for and clear blockages. Normal wear and tear, including normal wearing parts, such as belt, filter, brush bar, hose assembly and power cord (or where external damage or abuse is diagnosed). Carpet damage due to use not in accordance with flooring manufacturer’s instructions or failure to turn the brush bar off when necessary. Attach the cleaner head by sliding it on to the connections on the lower front part of the ball. Ensure the electrical plug on the cleaner head fits into the twin-block connection on the body of the appliance, which is directly above the airway. Ensure the cyclone and clear bin unit is secured to the main body of the appliance. Ca/AB12gettingstarted EMPTYING THE CLEAR BIN • • • • • • • • Switch ‘OFF’ and unplug before emptying the clear bin. Empty as soon as the dirt reaches the level of the MAX mark – do not overfill. After use, return the appliance to the upright position, pushing it firmly into place. Then: unplug the appliance, coil the cord safely, put the appliance away. Switch ‘OFF’ the appliance, unplug and ensure it is upright before: – changing or using tools – removing the hose or airway inspection parts. CLEANING THE CLEAR BIN • • Remove the cyclone and clear bin (instructions above). To separate the cyclone unit from the clear bin press the red button to open the clear bin base. Press the silver button and separate the cyclone unit from the clear bin. Do not use detergents, polishes or air fresheners to clean the clear bin. Clean the cyclone shroud with a dry cloth or dry brush to remove lint and dust. To refit the clear bin to the cyclone unit: – it the cyclone shroud into the clear bin so that the silver button clicks and f engages – close the clear bin base so it clicks into place –  ush the cyclone and clear bin unit into the main body of the appliance; p it will click into place – ensure the cyclone and clear bin unit is secure. If this happens, we recommend vacuuming in ‘hard floor’ mode and consulting with the flooring manufacturer. wASHING YOUR FILTERS • • • • • • • • • Your appliance has two washable filters , located as shown. [. . . ] Most questions can be solved over the phone by one of our Dyson Helpline staff. If your Dyson appliance needs service, call the Dyson Helpline so we can discuss the available options. If your appliance is under warranty, and the repair is covered, it will be repaired at no cost. The rating plate is on the top of the appliance above the switches, under the wand handle. [. . . ]