User manual DYNASTY SPAS EXCALIBUR-MC-MP-DY4 SPA PACK-JUNE 05

[. . . ] If the LEDs remain off for more than 5 sec. , the color/ display sequence will reset and start back at the beginning the next time the Light key is pressed. Color/ display sequences are: 1· LEDs light up and slowly cycle through all six colors. 8· LEDs light up for 2 sec. , flash off, then flash on in the next color until all six colors have been displayed. [. . . ] Our Smart Winter Mode protects your system from the cold by automatically turning the pumps on for one minute several times a day to prevent water from freezing in pipes. Press any key to reset the system, then reprogram all desired parameters. Water temperature is displayed. The system will reset automatically when water reaches 109°F (43°C). Call your dealer or service supplier if problem persists. 3 flashing dots are displayed. Call your dealer or service supplier if problem persists. Inverted display: Press and hold Pump 2 for 5 seconds to invert the display. If a power-up occurs, the display always returns to default mode. Quick Reference Card 7 Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step Programming Sequence Time of day Filter cycle start time Filter cycle duration Filter cycle frequency Economy mode start time Economy mode duration Storing settings in memory & returning to Normal mode Filter Cycle icon Programming Mode icon Temperature unit Heater icon Up & Down arrows Lock icon Economy Mode icon Step 1- Time of day Setting the time: 10:25 am 11:43 pm Digital control pad lockout This function allows you to prevent unauthorized parameter setting of the unit. This feature is especially helpful when young children have access to the keypad. Partial lock means that the basic functions of the spa will remain accessible (pumps, blower and light), but it will be impossible to change the temperature Set Point, to override the Economy mode or to enter the Programming mode. When control pad is locked, the "Lock" icon will be displayed. Locking your digital control pad: 1- Press and hold Pump 1 key for 5 seconds. 2- The display will show LocP, with "P" representing Partial lock. Keep key pressed down for 5 more seconds if you want to be in Full lock mode. The "LocF" message will then be displayed. 1- Enter Programming mode by holding Prog. 5- Use Up and Down arrows to change minutes setting. Steps 2 & 3- Filter cycle start time & duration The system automatically performs two filter cycles per day, at 12-hour intervals. During the filter cycle, Pumps 1 & 2 will run the first minute, then Pump 3 will run for one minute. The "Filter Cycle" icon lights up when a filter cycle is on. To program a filter cycle, you must enter: 1) the time you want the cycle to start and 2) the duration of the cycle. If no filtering is required, the duration should be set to "0". [. . . ] 3- Keep key pressed down until the desired mode is displayed. Step 4- Filter cycle frequency Setting filter cycle frequency: FF01 FF04 1- Press Prog. 2- The display will show FFxx, with "xx" representing the frequency per day. 3- Use Up and Down arrows to change setting. Steps 5 & 6- Economy mode start time & duration* Setting Economy mode start time: ES10 ES08 noEc Ec 1 1- Press Prog. [. . . ]