User manual DYNASTY SPAS EXCALIBUR-MC-MP-CE SPA PACK-JUNE 05

[. . . ] The LEDs will go off with the first press, then back on in the next setting with the second press. If the LEDs remain off for more than 5 sec. , the color/ display sequence will reset and start back at the beginning the next time the Light key is pressed. Color/ display sequences are: 1· LEDs light up and slowly cycle through all six colors. 8· LEDs light up for 2 sec. , flash off, then flash on in the next color until all six colors have been displayed. [. . . ] Our Smart Winter Mode protects your system from the cold by automatically turning pumps on for one minute several times a day to prevent water from freezing in pipes. The system will reset automatically when water reaches 43°C (109°F). Call your dealer or service supplier if problem persists. 3 flashing dots are displayed. Call your dealer or service supplier if problem persists. Setting water temperature: Use Up or Down arrow key to regulate water temperature. The temperature setting will be displayed for 5 seconds to confirm your new selection. The "Set Point" symbol indicates the desired temperature, NOT the current water temperature!Water temperature can be adjusted by 0. 5°C or 1°F increments from 15 to 40°C (59 to 104°F). Quick Reference Card K-4 keypad is mandatory when some options are selected. * Filter cycles The system automatically performs 2 filter cycles per day, at 12hour intervals. Pump 1 then runs at low speed for the remaining of the cycle and "Filter Cycle" icon lights up. (If system is equipped with a circulation pump, all pumps and blower run for one minute. Circulation pump then runs for the remaining of the cycle and "Filter Cycle" icon lights up. ) Setting filter cycles: FD10 Digital control pad lockout This function allows you to prevent unauthorized parameter setting of the unit. This feature is especially helpful when young children have access to the keypad. Partial lock means that the basic functions of the spa will remain accessible (pumps, blower and light), but it will be impossible to change the temperature Set Point, to override the Economy mode or to enter the Programming mode. When control pad is locked, the "Lock" icon will be displayed. Locking your digital control pad: LocP LocF FS06 1- Press Filter key. 2- The display will show FDxx, with "xx" representing the duration in hours. 5- The display will show FSxx, with "xx" representing the delay before cycle starts. 7- Press Filter key to store settings. 40-minute filter cycle time-out: If you turn a pump, blower or light on during a filter cycle, the cycle will be interrupted and will only resume 40 minutes after the system has turned the last active output off. 1- Press and hold Econo key for 5 seconds. [. . . ] 2- The display will show EDxx, with "xx" representing the Economy mode duration. 5- The display will show ESxx, with "xx" representing the delay before mode starts. 7- Press Econo key a third time to store settings. "CLE" message Every two weeks, the "CLE" message might be displayed indicating to clean the filter (depending on your spa configuration). Press any key to reset the message. 40-minute Economy mode time-out: If you turn a pump, blower or light on while Economy mode is on, the Economy mode will be interrupted and will only resume 40 minutes after the system has turned the last active output off. [. . . ]