User manual DYNASTY SPAS EXCALIBUR 5000

[. . . ] A third time turns 12V light off and a fourth time shut fiber box light. The "Light" icon is displayed when fiber box motor is off and both lights on (or only the fiber box light). It flashes when fiber box (motor & light) and 12V light are on. Setting water temperature: Use Up or Down arrow key to regulate water temperature. The temperature setting will be displayed for 5 seconds to confirm your new selection. [. . . ] It flashes when blower is on at low speed. Pumps have started up for one minute on several occasions and "Filter Cycle" icon is flashing. Our Smart Winter Mode protects your system from the cold by automatically turning the pumps on for one minute several times a day to prevent water from freezing in pipes. Press any key to reset the system, then reprogram all desired parameters. Water temperature is displayed. The system will reset automatically when water reaches 109°F (43°C). Call your dealer or service supplier if problem persists. 3 flashing dots are displayed. Call your dealer or service supplier if problem persists. Temperature display unit: Press and hold Light key for 5 seconds to display water temperature in either Fahrenheit (°F) or Celsius (°C). Quick Reference Card 7 Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step Programming Sequence Time of day Filter cycle start time Filter cycle duration Filter cycle frequency Economy mode start time Economy mode duration Storing settings in memory & returning to Normal mode Filter Cycle icon Programming Mode icon Temperature unit Heater icon Up & Down arrows Economy Mode Lock icon icon Step 1- Time of day Setting the time: 10:25 am 11:43 pm Digital control pad lockout This function allows you to prevent unauthorized parameter setting of the unit. This feature is especially helpful when young children have access to the keypad. Partial lock means that the basic functions of the spa will remain accessible (pumps, blower and light), but it will be impossible to change the temperature Set Point, to override the Economy mode or to enter the Programming mode. When control pad is locked, the "Lock" icon will be displayed. Locking your digital control pad: 1- Press and hold Pump 1 key for 5 seconds. 2- The display will show LocP, with "P" representing Partial lock. Keep key pressed down for 5 more seconds if you want to be in Full lock mode. The "LocF" message will then be displayed. 1- Enter Programming mode by holding Prog. 3- Use Up and Down arrows to change setting. Steps 2 & 3- Filter cycle start time & duration The system automatically performs two filter cycles per day, at 12-hour intervals. During the filter cycle, Pumps 1 & 2 and the blower will run the first minute, then Pump 3 will run for one minute. The "Filter Cycle" icon lights up when a filter cycle is on. To program a filter cycle, you must enter: 1) the time you want the cycle to start and 2) the duration of the cycle. If no filtering is required, the duration should be set to "0". [. . . ] 3- Keep key pressed down until the desired mode is displayed. Step 4- Filter cycle frequency Setting filter cycle frequency: FF01 FF04 1- Press Prog. 2- The display will show FFxx, with "xx" representing the frequency per day. 3- Use Up and Down arrows to change setting. Steps 5 & 6- Economy mode start time & duration* Setting Economy mode start time: ES10 ES08 noEc Ec 1 1- Press Prog. 2- The display will show ESxx, with "xx" representing the starting hour. [. . . ]