User manual DYNASTY SPAS EXCALIBUR 3000-4000

[. . . ] The Quick Reference Card provides a quick overview of your spa's main functions and the operations accessible with your digital control pad. SC-MP-DY1 / Dual-Pump System Starting Pump 1: Press Pump 1 to turn Pump 1 on at low speed. When at high speed, a built-in timer turns pump off after 20 minutes and when at low speed after 2 hours, unless manually deactivated first. [. . . ] The "Pump 2" indicator lights up when Pump 2 is on. Automatic water heater start: When water temperature is 1°F (0. 5°C) lower than the Set Point, the heater will automatically turn on until water temperature reaches Set Point plus 1°F (0. 5°C). It flashes when there is a request for more heat but the heater has not yet started. N. B. : If your system is configured in Low Current Mode, the heater will not start if a pump is on at high speed. Setting water temperature: Use Up or Down arrow keys to regulate water temperature. The temperature setting will be displayed for 5 seconds to confirm your new selection. The "Set Point" indicator displays the desired temperature, NOT the current water temperature!Water temperature can be adjusted by 1° increments from 59 to 104°F (15 to 40°C). Economy mode: Press Econo key to switch from Normal mode to Economy mode. In Economy mode, system maintains temperature at the desired Set Point during filter cycles only. Set Point is 20°F (11°C) below the Normal mode Set Point for the rest of the time. In Economy mode, the display will toggle between the current water temperature and the "Econ" message. Temperature display unit: Press and hold Light key for 5 seconds to display water temperature in either Fahrenheit (°F) or Celsius (°C). If a power-up occurs, system returns to default setting (°F). Quick Reference Card PROGRAMMING FILTER CYCLE DURATION The system automatically performs two filter cycles per day, at 12-hour intervals. During a filter cycle: · Pump 2 runs for one minute, then · Pump 1 runs at low speed for the programmed number of hours The "Filter Cycle" indicator lights up when the filter cycle is on. To set filter cycle duration: Press and hold Filter key until the display shows "xx", representing the currently set filter cycle duration in hours. Use Up or Down arrow keys to change setting. [. . . ] The system will reset automatically when water temperature reaches 109°F (43°C). Press any key to reset the system, then reprogram all desired parameters. 3 flashing dots are displayed. ·E QU IPP ITH GECKO'S EX ED W CLU Smart Winter Mode TM SIV E· 9919-100418-B [. . . ]