User manual DURACRAFT DH890

[. . . ] Never tilt or attempt to move the humidifier while it is operating or filled with water. Never clean the humidifier in any manner other than as instructed in this manual. Turn the humidifier OFF if the relative humidity exceeds 60%, or if you notice moisture on the inside of your windows. For proper humidity reading use a hygrometer, which is available in many hardware and department stores or by ordering one from the manufacturer (see Care Products). INTRODUCTION Thank you for purchasing a Duracraft® Natural Cool Moisture® humidifier. [. . . ] · Replace the fill cap by turning it clockwise tank right-side up. Turn the water FILLING CONTINUED NOTE: WHEN CARRYING THE FILLED WATER TANK, PLEASE USE THE HANDLE AND PLACE YOUR OTHER HAND UNDER THE TANK FOR ADDITIONAL SUPPORT. · Once the filled tank has been positioned, do not attempt to move the humidifier. If it has to be moved, unplug the humidifier and remove the water tank first. NOTE: DO NOT POUR WATER INTO THE GRILL ON THE TOP OF THE MOTOR HOUSING. DOING SO MAY DAMAGE THE HUMIDIFIER OR CAUSE PERSONAL INJURY. O P E R AT I O N CAUTION: DO NOT PLUG IN THE HUMIDIFIER WITH WET HANDS AS AN ELECTRIC SHOCK COULD OCCUR. POWER · With the power switch in the OFF position, plug the filled humidifier into a polarized 120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET; it will only fit one way. HUMIDITY CONTROL 1. 4 f Of High Lo w NOTE: The length of time your humidifier runs will vary depending on the quality of construction and insulation of your room and house, as well as the fan speed. Turn the humidifier OFF if the humidity level feels too moist or you notice condensation forming on the walls and/or windows. ALWAYS be sure to empty any unused water in the Rinse-to-Clean® Base and/or Water Tank each time you refill the water tank or finish using the humidifier. W E E K LY C L E A N I N G We recommend cleaning the humidifier once a week, more often if you have hard water or notice a build up of impurities or detect unpleasant odors. NOTE: THE USE OF OTHER WATER TREATMENT PRODUCTS MAY DAMAGE THE FILTER OR HUMIDIFIER. Cleaning involves two steps SCALE REMOVAL and DISINFECTING. Be sure to perform these in the proper order to avoid harmful chemical interactions. · Remove the Water Tank and Motor Housing. · Remove the Natural Cool Moisture® filter from the Rinse-to-Clean® Base. · Discard any residual water from the Base. THIS MAY DAMAGE THE HUMIDIFIER OR CAUSE ELECTRIC SHOCK. NOTE: Remove filter before cleaning Failure to remove the filter during cleaning will destroy the filter STEP ONE: STEP TWO: SCALE REMOVAL Rinse-to-Clean® Base 1. Fill the Rinse-to-Clean® Base with either: · one cup (8 ozs) of undiluted white vinegar OR · DuraRinse Humidifier Cleaner, part no. AC-816, following bottle instructions ® DISINFECTING Water Tank 1. Fill the water tank with: · 1 teaspoon of household bleach · 1 gallon of water. With the vinegar or DuraRinse® in the Rinse-to-Clean® Base clean all interior surfaces with a soft cloth or brush to help remove scales. Rinse the Rinse-to-Clean® Base thoroughly with water to remove scale and cleaning solution. P R O L O N G I N G T H E L I F E O F T H E F I LT E R A N D M A I N TA I N I N G A C L E A N H U M I D I F I E R NOTE: DO not attempt to clean the Natural Cool Moisture® filter with any chemical solutions, doing so will damage the filter. · If the Natural Cool Moisture® filter appears to be clogged by hard water or mineral deposits, soak it in a sink full of cool water for 10 minutes. There are many steps you can take each time you fill your humidifier to make sure you get the most life out of our Natural Cool Moisture® filter. To prevent mineral deposits use DuraFree® Humidifier Descaler Water Softener, part no. DO NOT squeeze or wring it out, DO NOT clean the filter using any chemical solution. [. . . ] If the humidity level is over 60%, the unit will not put out much moisture as your air is already saturated. Q: My filter has turned light brown and rust colored. Since your filter has been made with AgIONTM technology the change in color indicates only a mineral deposit. The discoloration may remain but will not effect the humidifier's performance. E L E C T R I C A L R AT I N G S This product is rated at 0. 6 amps, 120V, 60 Hz. NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HUMIDIFIER PLEASE SEE THE WARRANTY INSTRUCTIONS. DOING SO WILL VOID THE WARRANTY AND COULD CAUSE DAMAGE TO THE UNIT OR PERSONAL INJURY. [. . . ]