User manual DUCATI CTR45

[. . . ] When the motors are connected to the mains power the torque they apply to the gate must respect the applicable rules and, in any case, it must be such that in case of collision no damage will be caused to persons, animals or objects. Note 8 ­ The unit must be applied for the intended use only (see point A). Note 9 ­ Before acceding to the electronic unit's box for any intervention check that the mains power has been cut off. ) Note 12 ­ Do not allow any children or unqualified persons to touch the unit. [. . . ] Therefore the unit can determine, with a fair approximation, the partial working time necessary to the wing to end its travel. Thanks to this feature it is possible to avoid that the motor works for a long time after the end of the wing's travel, thus reducing overheating to the minimum. Warning : In case of absence of power supply the stored position will be lost. It is usually employed to help the electric lock release during bad weather conditions (wind, ice, etc. The "kickback" procedure consists of a logic sequence operating the electric lock during a short closure phase (approx 1 sec. The electric lock is released only after the wing has started its opening motion. 2 seconds between the first wing's (M2) and the second wing's (M1) start during the gate's opening phase. This delay is imposed irrespective of the position from which the gate starts to open. The unit can operate in three modes : - Step by step - Automatic - Condominium The Condominium mode is the priority operation mode. If more than one modes are selected the priority mode will be enabled. Notice: The operation logic setting (dip switch), the work time programming and the pause time programming must be carried out only if the cycle is concluded or before it starts (with closed gate). "Step-by-step" mode After the power is supplied to the electronic card the first start command determines an opening cycle. The operating cycle is completed (blinker off) and the system waits for a new start command to determine the closing cycle. If a start command is supplied when the end of travel has not been reached yet the gate stops. "Automatic" mode After the power is supplied to the electronic card the first start command determines an opening cycle. The operating cycle is complete only when the closing motion has ended. If a start command is supplied before the end of travel is reached the gate stops. If a start command is supplied during the pause period the operating cycle is interrupted (blinker off) and the gate does not close automatically. "Condominium" mode After the power is supplied to the electronic card the first start command determines an opening cycle. The operating cycle is complete only when the closing motion has ended. If a start command is supplied while the gate opens, the command will have no effect. If a start command is supplied while the gate closes, the gate will stop and reverse its motion after approx. [. . . ] Let the desired delay time pass, then press the key P1 again to start the motor M2. When the motor M1 has arrived at the end of travel, press the key P1 for the third time. When the motor M2 has arrived at the end of travel, press the key P1 for the fourth time. Setting the work time (2-wings gates without any time delay) remove the Jumper JP1 and insert the Jumpers JP3 and JP2. [. . . ]