User manual DUCATI CTR32

[. . . ] Before acceding to the electronic unit's box for any intervention check that the mains power has been cut off. Therefore it must be installed in an well aired place far from any objects or elements that can cause fire. The ordinary maintenance of electronic unit must be executed by qualified personnel every 6 months. Failure to respect the above listed norms can cause damage to persons, animals or objects. [. . . ] The radio receiver operates with a self-learning logic and can store up to 12 different codes from the radio-commands. Each code may be addressed on the desired channel (Start or Pedestrian start). in alternative the electronic unit is pre-set for the optional connection of an accessory radio receiver card. The channel 1 of the radio receiver card ends with a non-polarized electric contact (relay) directly connected to the start input. The channel 2 of the radio receiver card ends with a non-polarized electric contact (relay) directly connected to the pedestrian start input. Quick flashing light : it signals the opening phase Slow flashing light : it signals the closing phase Fixed light : it signals that the gate is blocked in wait that the obstacle that covers the photocell or photostop to be removed. Open gate lamp The electronic card controls a lamp that displays the gate's position. The lamp is off when the gate is completely closed and is lit in all other cases. Work time The motors' work time is controlled by two independent digital timers. If any command interrupts the wing's travel before its end, the Timer stops and the elapsed time is stored in memory. Therefore the unit can determine, with a fair approximation, the partial working time necessary to the wing to end its travel. Thanks to this feature it is possible to avoid that the motor works for a long time after the end of the wing's travel, thus reducing overheating to the minimum. Warning : In case of absence of power supply the stored position will be lost. It is usually employed to help the electric lock insertion and release during bad weather conditions (wind, ice, etc. The "kickback" procedure consists of a logic sequence operating the electric lock during a short closure phase (approx 1 sec. The electric lock is released only after the wing has started its opening motion. The "extra-push" procedure is enabled only during the closing slow-down phase near at the end of the wings' travel. 2 seconds between the first wing's (M2) and the second wing's (M1) start during the gate's opening phase. This delay is imposed irrespective of the position from which the gate starts to open. These are the four main operation phases : Phase preceding the gate's motion Gate's fast motion phase Gate's slow motion phase Gate's pause phase (open gate) The unit can function in three modes : Step by step ­ This mode is enabled by setting the dip switches 1=OFF 2=OFF Automatic ­ This mode is enabled by setting the dip switches 1=OFF 2=ON Condominium­ This mode is enabled by setting the dip switches 1=ON 2= No effect The Condominium mode is the priority operation mode. If more than one modes are selected the priority mode will be enabled. Notice: The operation logic setting (dip switch), the work time programming and the pause time programming must be carried out only if the cycle is concluded or before it starts (with closed gate). [. . . ] Company name and registered office : Description of the appliance : Model : Reference rules applied : Basic rules applied : Test laboratory : Outcome : Electronic board for the control of 1 or 2 230 Vac single-phase asynchronous motors for gate automation. Radio-command codes self-learning: Press the P1 key once to insert a "Start" code; press the P1 push-button twice to insert a "Pedestrian Start" code. When the led is lit with a fixed light transmit the code to be learn by means of the radio-command. Erasing all stored codes: Press push-button P1 until the led DL1 goes off (about 10 seconds). [. . . ]