User manual DUCATI CTR31

[. . . ] When the motor is connected to the mains power the torque it apply to the gate must respect the applicable rules and, in any case, it must be such that in case of collision no damage will be caused to persons, animals or objects. Before acceding to the electronic unit's box for any intervention check that the mains power has been cut off. Therefore it must be installed in an well aired place far from any objects or elements that can cause fire. The ordinary maintenance of electronic unit must be executed by qualified personnel every 6 months. [. . . ] Power regulator Regulating the RV1 trimmer it is possible reduce the power supplied to the motor during the normal speed phase. Caution: In case failure or anomaly of the electronic card the motor may operate at its maximum power value. This is why n° 7 note in the previous chapter "limits to use" must absolutely be put into practice. Starting of maximum start up power When the motor starts the unit supplies the maximum power value for approx. Radioreceiver The electronic unit contains a two-channel radio receiver allowing remote control of the gate by means of the radio transmitter. The radio receiver operates with a self-learning logic and can store up to 12 different codes from the radio-commands. in alternative the electronic unit is pre-set for the optional connection of an accessory radio receiver card. The channel 1 of the radio receiver card ends with a non-polarized electric contact (relay) directly connected to the start / opening start input. The channel 2 of the radio receiver card ends with a non-polarized electric contact (relay) directly connected to the pedestrian start / closing start input. Quick flashing light : it signals the opening phase Slow flashing light : it signals the closing phase Fixed light : it signals that the gate is blocked in wait that the obstacle that covers the photocell or photostop to be removed. Work time The motor's work time is controlled by one digital timer. If any command interrupts the gate's travel before its end, the Timer stops and the elapsed time is stored in memory. Therefore the unit can determine, with a fair approximation, the partial working time necessary to the gate to end its travel. Thanks to this feature it is possible to avoid that the motor works for a long time after the end of the gate's travel, thus reducing overheating to the minimum. Warning : In case of absence of power supply the stored position will be lost. These are the four main operation phases : Phase preceding the gate's motion Gate's fast motion phase Gate's slow motion phase Gate's pause phase (open gate) The unit can function in three modes : Step by step ­ This mode is enabled by setting the dip switches 1=OFF 2=OFF Automatic ­ This mode is enabled by setting the dip switches 1=OFF 2=ON Condominium ­ This mode is enabled by setting the dip switches 1=ON 2= No effect The Condominium mode is the priority operation mode. If more than one modes are selected the priority mode will be enabled. Notice: The operation logic setting (dip switch), the work time programming and the pause time programming must be carried out only if the cycle is concluded or before it starts (with closed gate). the operating cycle is enabled by a Opening Start or Closing Start control. "Step-by-step" mode When the gate is closed, the opening start command determines an opening cycle. the operating cycle is completed (blinker off) and the system waits for a closing start command to determine the closing cycle. If a opening start or closing start command is supplied when the end of travel has not been reached yet the gate stops. [. . . ] Radio-command codes self-learning : Press the P1 push-button once to insert a "Opening Start" code; press the P1 push-button twice to insert a "Closing Start" code; press the P1 push-button three times to insert a "Pedestrian Start" code". When the led is lit with a fixed light transmit the code to be learn by means of the radio-command. Warning : In Ciclical mode (dip switch 4 = ON) the opening start and closing start commands become, respectively, start and pedestrian start. Erasing all stored codes : Press push-button P1 until the led DL1 goes off (about 10 seconds). [. . . ]