User manual DUCATI CTR29

[. . . ] Note 8 - The unit must be applied for the intended use only (see point A). All other use is to be considered improper and dangerous ENGLISH Note 9 Before acceding to the electronic unit's box for any intervention check that the mains power has been cut off. Therefore it must be installed in an well aired place far from any objects or elements that can cause fire. Note 15 - The ordinary maintenance of electronic unit must be executed by qualified personnel every 6 months. [. . . ] 6) DEFINITIONS OF TIMERS Work time It defines the motor's work time during the opening or closure phases. 7) DEFINITIONS OF JUMPERS (SELECTION OF PROGRAMS) JP1 jumper It determines whether the unit will operate in step-by-step, manual or cyclical mode. ENGLISH 8) DEFINITION OF PROTECTION FUSE F1 - Mains power fuse (5A) It disconnects the electronic unit from the power supply mains in case of short-circuit or electric current consumption anomalies. 9) TECHNICAL FEATURES Radioreceiver The electronic unit contains a two-channel radio receiver allowing remote control of the roller shutter by means of the radio transmitter. the radio receiver channel 1 acts as Opening start , whereas channel 2 acts as Closing start. The radio receiver operates with a self-learning logic and can store up to 120 different codes from the radio-commands. Each code may be addressed on the desired channel (opening start or closing start). Work time The motor's work time is controlled by one digital timer. For the automation system to work properly the operating time value to be set must be slightly (min. If any command interrupts the roller shutter's travel before its end, the Timer stops and the elapsed time is stored in memory. Therefore the unit can determine, with a fair approximation, the partial working time necessary to the roller shutter to end its travel. In case of limit switch lack, thanks to this feature it is possible to avoid that the motor works for a long time after the end of the roller shutter's travel, thus reducing overheating to the minimum. Warning : In case of absence of power supply the stored position will be lost. These are the main operation modes : "Step-by-step" mode (JP1 jumper = not inserted) When the roller shutter is closed, the opening start command determines an opening cycle. If a opening start or closing start command is supplied when the end of travel has not been reached yet the roller shutter stops. Manual (JP1 jumper = inserted between 3 and 2 ) The roller shutter move until the (opening or closure) push-button is pressed. Note : The opening start and closing start commands can be supplied by the two push-buttons of radio-command. "Cyclical" mode (JP1 jumper = inserted between 1 and 2 ) In cyclical mode the difference between the opening start and closing start commands is cancelled and both commands have the same function. Notice: The operation logic setting (jumper) and the work time programming must be carried out only if the cycle is concluded or before it starts (with closed roller shutter). ENGLISH 11) ELECTRICAL AND MECHANICAL SPECIFICATIONS Dimensions and weight : 88 x 127 x 58 mm ­ 0, 3 Kg Mains power supply : 230 Vac +/- 10% Operating temperature range : 0 to + 60 °C Single-phase motor power supply : 230 Vac 1 HP max Motor's work time : programmable, 1 to 250 sec. [. . . ] The Manufacturer is not responsible for missing observance of rules above described. f) CONFORMITY DECLARATION (To EMC directive EN45014 and ISO guide 22). 01 Reference rules applied : EN 50081-1, EN 50082-1, EN 55014 Basic rules applied : EN 61000-3-2, EN 61000-3-3, EN 61000-4-4, EN 61000-4-2, ENV 50140 Test laboratory : Intek s. Radio-command codes self-learning : Press the P1 push-button once to insert a "Opening Start" code; press the P1 push-button twice to insert a "Closing Start" code. [. . . ]