User manual DREAMGEAR DGWII-3147

[. . . ] If a replacement is necessary and your product is no longer available, a comparable product may be substituted at the sole discretion of dreamGEAR. This warranty does not cover normal wear and tear, abusive use or misuse, modification, tampering or by any other cause not related to either materials or workmanship. This warranty does not apply to products used for any industrial, professional or commercial purposes. [. . . ] This prevents you from having to remove and replace the battery cover when syncing. After opening the SD Card Slot cover on the front of the Wii Console, press the SYNC button on the Wii Console. After the syncing process, the LED that is lit shows the player number for that remote. NOTE: You must follow the above instructions for each additional ACTION REMOTE CONTROLLER PLUS added to the Wii Console. Motion Sense Technology The ACTION REMOTE CONTROLLER PLUS has built in Motion Sense Technology, which allows the controller full compatibility with all Wii MotionPLUS games. "Motion Sense"TM Technology allows the most precise 1:1 movement possible and because it is built in, no extra attachments are needed. NOTE: Please refer to the User's Guide of each individual game to check the Wii MotionPLUS compatibility. the ACTION REMOTE CONTROLLER PLUS will automatically use Motion Sense Technology depending on the game. Standby Mode: The ACTION REMOTE CONTROLLER PLUS will automatically enter standby mode if not in use for 5 minutes. Insert the PLAY CONTROLLER plug into the bottom of the ACTION REMOTE CONTROLLER PLUS or Wii Remote until it makes a "click" sound. Make sure that you do not over tighten the strap lock and make it uncomfortable to play with. To disconnect the PLAY CONTROLLER from the ACTION REMOTE CONTROLLER PLUS or Wii Remote, press and hold the lock/release levers (located on the sides of the PLAY CONTROLLER plug) and pull the plug straight out of the ACTION REMOTE CONTROLLER PLUS or Wii Remote. notes: · Always use your remote with the wrist strap included. When using "AA" batteries, the remaining battery life of the ACTION REMOTE CONTROLLER PLUS can be shown by pressing the HOME button on ßthe remote. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does not cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. You are cautioned that any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ]