User manual DREAM MULTIMEDIA DREAMBOX 7000-S

[. . . ] Conversion or modification of the unit leads to loss of warranty if not carried out by a specialist dealer and certified in writing. An incorrect installation of the hard disk results in you losing all of your rights under the guarantee. If the unit is not operated for longer periods of time, it should be completely disconnected from the mains power supply. â· The unit should also be disconnected from the mains supply during electrical storms. [. . . ] Before you connect the receiver, please read the safety instructions under point 2. connect the external device (Spiegel , LNB) with an F plug to the LNB input on the receiver. Connect the receiver with a Scart cable to your television (Scart socket TV), and to a video recorder or DVD player (Scart socket VCR). Plug the mains cable into the receiver and then into a suitable power socket 230V / 50Hz. 1 Analog To connect your Dreambox to a hifi amplifier, please use a suitable phono cable Connect this to the receiver at AUDIO R/L and to a free input (e. 2 Digital If your amplifier has a suitable optical input, connect the DIGITAL AUDIO socket on the receiver to the optical input of the amplifier with an optical cable. This output also provides the Dolby Digital-Signal (AC3) when this is broadcast. 2 RS 232 serial interface The RS 232 interface is used to update the operating software and for preprogramming with a PC. 3 Ethernet The Ethernet interface can be used to update the operating software and for pre-programming with a PC. Take care that dead batteries from the remote control and electronic scrap are not disposed of in ordinary rubbish, but are properly disposed of (return to the specialist dealer, or special waste disposal). All available options are displayed over 4 coloured dots (red, green, yellow, blue) and can be activated with the remote control. The options change depending on the menu, and are labelled appropriately in each menu. 2 Set-up-menu Leave the menu with "close" or with "LAME!After entering your set-up, save your settings with "save", or , , abort". After entering your set-up, save your settings with "save", or , , abort". After entering your set-up, save your settings with "save", or , , abort". After entering your set-up, save your settings with "save", or , , abort". After entering your set-up, save your settings with "save", or , , abort". [. . . ] Standby, Power down Dreambox and Reset Channel options (green) Audio (yellow) Encoded Dolby Digital To put your Dreambox into standby mode, briefly press the power key on your remote control once. To put your Dreambox into deep standby, go to the main menu, select the "power down" option, and confirm this with the "OK" key. All settings are now stored and the Box goes into deep standby, or press the power key on the remote control for 5 seconds. Set up "TV control mode" A four-digit TV device code is selected from the TV model list in the table in Chapter 13 (pages 23 - 32) and entered. [. . . ]