User manual DOD VOTEC

[. . . ] POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. [. . . ] To re-engage the VoTEC, press any footswitch. Factory reset Caution this function will revert VoTEC to factory default. Hold down both the Compressor and Reverb buttons while powering up the VoTEC. The VoTEC has now reverted to factory default. ACCESSORIES FOR THE VoTEC Gig Bag VCC1 Volume Continuous Controller DECLARATION OF CONFORMITY DOD Electronics 8760 South Sandy Parkway Sandy, Utah, 84070 Telephone (801) 566-8800 FAX (801) 566-7005 International Distribution: 3 Overlook Drive, Unit 4 Amherst, New Hampshire 03031 U. S. A. FAX (603) 672-4246 VoTEC is a registered trademark of DOD Electronics Copyright © 1998 DOD Electronics Printed in U. S. A. VoTEC Manufacturer's Name: DOD Electronics Corporation Manufacturer's Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product Product Name: VoTEC Product Options: All (requires a Class II power adapter that conforms to the requirements of EN 60065, EN 60742, or equivalent). Safety: EN 60065 (1993) IEC65 (1985) with Amendments 1, 2, 3 EN 55013: (1990) EN 55020: (1991) EMC: Supplementary Information: The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC as amended by directive 93/68/EEC. Sandy Parkway Sandy, Utah 84070, USA Effective: February 23, 1998 European Contact: Your Local DOD Sales and Service Office or International Sales Office 3 Overlook Drive #4 Amherst, New Hampshire 03031, USA Tel (603) 672-4244 Fax (603) 672-4246 Warranty 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DOD warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DOD liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DOD WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one (1) year. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. DOD reserves the right to make changes in design or make additions to or improvements upon this product without incurring any obligation to install the same on products previously manufactured. The foregoing is in lieu of all other warranties, expressed or implied, and DOD neither assumes nor authorizes any person to assume for it any obligation or liability in connection with the sale of this product. [. . . ] 100ms to 500ms increasing in 100ms steps, increasing feedback and delay mix. Reverb: 1-9 1-3: 4-6: 7-9: Room, 3 levels. Stadium, 3 levels. Compression: 1-3 1: 2: 3: Low Medium High Distortion: 1-15 1-8: 9-15: Overdrive, increasing gain. -12 to +12 in steps of 2 dB. EQ Low: EQ High: 18-2212-A QUICK S T ART K T 1. Safety Info: CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Read all safety instructions before operating VoTEC TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE A T T E N T I O N : RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR WARNING: 2. output Input Connection: Insert XLR cable from microphone to VoTEC input. [. . . ]