User manual DOD VGS50

[. . . ] OWNER'S MANUAL A Harman International Company The Sound of Your Imagination The symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit. The exclamation point in an equilateral triangle indicates that it is necessary for the user to refer to the owner's manual. These symbols warn that there are no user serviceable parts inside the unit. [. . . ] The steps outlined below will guide you through creating this preset. Page 9 1. If the compressor is bypassed (indicated by two dashes "--"), press the Compression button again, or rotate the Data Wheel to activate the compressor. Since we want a medium compression setting, roll the Data Wheel until the number 2 shows in the display. If the distortion is bypassed (indicated by two dashes "--" in the display), press the Distortion button again, or rotate the Data Wheel to activate the distortion. Since we want the Grunge distortion, and Grunge is listed in the group as number 5, roll the Data Wheel until the display shows the number 5. You will notice that the parameter LED next to the word "Gain" lights. This indicates that gain is a parameter associated with the distortion, and you may adjust this parameter. Press the Parameter Edit button once and the Gain LED will begin to flash indicating that you are now about to edit the distortion gain. Using the Data Wheel will increase or decrease the amount of distortion gain. The display will show either a positive number, or a negative number indicated by a minus sign (-). If the High EQ is bypassed it will be indicated by a "0" in the display. Roll the Data Wheel clockwise to boost the High EQ to a value of about "6". In order to get just the highs and lows boosted, we should bypass the Mid EQ. If the display does not show a "0, " press the Mid EQ button again to bypass the Mid EQ section. Roll the Data Wheel to give the lows a value of about "6" also. We wanted to set the noise gate threshold at a low setting, so press the effect select button in the Noise Gate box. If the noise gate is bypassed (indicated by two dashes "--" in the display), you will need to press the Noise Gate button again, or rotate the Data Wheel to activate the Noise Gate. Since we wanted a low threshold for the Noise Gate, roll the Data Wheel until the display shows the number 1. Page 10 5. If the effects in this group are bypassed (indicated by two dashes "-" in the display), press the Effect button again, or rotate the Data Wheel to activate this group. Chorus is listed as the first effect in this group so, roll the Data Wheel until the number "1" is shown in the display. You will notice that when you select Chorus as your effect type, the parameter LEDs next to Speed, Depth, and Mix/Level will light. This indicates that these three parameters are associated with the Chorus, and are available for adjustment. [. . . ] Be sure you want to erase the memory and start fresh before continuing with this procedure. Press and hold the Low EQ Select button, and the Parameter Select button while reconnecting the power. The display will briefly show "rS" to indicate that it has reset. After the reset has occurred, the expression pedal needs calibrating and is indicated by the letters "tdn" in the display. [. . . ]