User manual DMC ROADWIN R

[. . . ] OWNER S MANUAL IMPORTANT NOTICE WELCOME Thank you for purchasing an Daelim vehicle. OPERATOR AND PASSENGER This motorcycle is designed to carry the operator and one passenger. WARNING Attempting to change the pre-set maximum speed may cause danger and will void the Daelim warranty. ON-ROAD USE This motorcycle is designed to be used only on the road. READ THIS OWNER'S MANUAL CAREFULLY Pay special attention to statements preceded by the following words: WARNING Indicates a strong possibility of severe personal injury or death if instructions are not followed. CAUTION Indicates a possibility of personal injury or equipment damage if instructions are not followed. NOTE Gives helpful information. keep it with your vehicle at all times, even though your vehicle is resold. CONTENTS SPECIFICATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If the side stand is up, the Check to see if the MIL is illuminat for engine can be started in neutral or in 3 second. After starting with the side stand down, <WHEN ENGINE IS COLD > the engine will shut off if the transmission is put in gear before raising the side stand. <WHEN ENGINE IS HOT > 1. If engine is not started with throttle grip closed, open throttle grip approximately 1/8 to 1/4 and press starter button. WARNING Never run the engine in an enclosed area. The exhaust contains poisonous carbon monoxide gas that can cause loss of consciousness and lead to death. CAUTION Do not keep the starter button pressed for more than 5 seconds at a time. Release the starter button for approximately 10 seconds before pressing it again. Close throttle grip, and press starter button. 27 IF ENGINE CANNOT BE STARTED It is possible that starting will be more difficult if the vehicle has not been used for a long period of time or if the fuel hole is plugged up (starting problems even when there is sufficient fuel in the fuel tank may be an indication of a plugged fuel hole). When this happens, do not rotate the throttle grip and try the starter button a few times. If engine cannot be started or vehicle does not move, check the followings. Are you operating in accordance with the instructions given in user's manual?If starter motor is not running due to battery consumption, charge the battery. If the MIL blinks continously when the main key is on, inquiry to the daelim dealer. RUNNING-IN During initial running-in newly machined surfaces will be in contact with each other and these surfaces will wear in quickly. Running-in maintenance at 1, 000km is designed to compensate for this initial minor wear. Timely performance of the running-in maintenance will ensure optimum service life and performance from the engine. Maximum continuous engine speed during the first 1, 000km must not exceed 5, 000 rpm. NOTE Do not run engine idle unreasonably. If starter button is pressed in gear position, vehicle may bring out to fall. Make sure gear is in neutral position prior to starting engine. CAUTION Running the engine beyond recommended maximum engine speed (the beginning of the tachometer red zone) can damage the engine. 28 RIDING 1. After the engine has been warmed up, the motorcycle is ready for riding. While the engine is idling, pull in the clutch lever and depress the gearshift pedal to shift into 1st (low) gear. Slowly release the clutch lever and at the same time gradually increase engine speed by opening the throttle. Coordination of the throttle and clutch lever will assure a smooth positive start. When the motorcycle attains a moderate speed, close the throttle, pull in the clutch lever and shift to 2nd gear by raising the gearshift pedal. This sequence is repeated to progressively shift to 3rd, 4th, 5th (top) gear. [. . . ] Hands : Grip the handle the position away from the inside end of the handle with distance of one finger to facilitate the operation of the switch and lever. Wrist : Keep the state to act freely without applying excessive force to the shoulder and arms. Feet : Place the feet to face the front parallel and make the step bar be placed in the center of feet. 52 PRECAUTION WHEN DRIVING Secure the safe distance. If any abnormality is found, stop driving and contact service center to inspect the vehicle. [. . . ]