User manual DMC ROADWIN FI

[. . . ] OWNER S MANUAL IMPORTANT NOTICE WELCOME Thank you for purchasing an Daelim vehicle. OPERATOR AND PASSENGER This motorcycle is designed to carry the operator and one passenger. WARNING Attempting to change the pre-set maximum speed may cause danger and will void the Daelim warranty. ON-ROAD USE This motorcycle is designed to be used only on the road. READ THIS OWNER'S MANUAL CAREFULLY Pay special attention to statements preceded by the following words: WARNING Indicates a strong possibility of severe personal injury or death if instructions are not followed. CAUTION Indicates a possibility of personal injury or equipment damage if instructions are not followed. NOTE Gives helpful information. keep it with your vehicle at all times, even though your vehicle is resold. CONTENTS SPECIFICATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Side stand switch ignition cut-off system - check for proper function (page 44). Angle rear view mirror. CAUTION Observe safety rules when conducting inspections. Conduct inspections on a flat, solid ground with the main stand erected. If you are unable to correct trouble even after you make adjustment or correction, contact authorized maintenance shops, dealers or designated repair shops for necessary inspection and repairs. 26 STARTING THE ENGINE Always follow the proper starting procedure described below. This motorcycle is equipped with a side stand ignition cut-off system. The engine cannot be started if the side stand is down, unless the transmission is in neutral. If the side stand is up, the engine can be started in neutral or in gear with the clutch lever pulled in. After starting with the side stand down, the engine will shut off if the transmission is put in gear before raising the side stand. <PREPARATION> Before starting, insert the key, turn the ignition switch ON and confirm the following: The transmission is in NEUTRAL (neutral indicator light ON) 2. Once engine is started, pull and release throttle grip repeatedly to run engine idle until engine is heated. Check to see if the MIL is illuminat for 3 second. <WHEN ENGINE IS COLD > <WHEN ENGINE IS HOT > 1. If engine is not started with throttle grip closed, open throttle grip approximately 1/8 to 1/4 and press starter button. WARNING Never run the engine in an enclosed area. The exhaust contains poisonous carbon monoxide gas that can cause loss of consciousness and lead to death. CAUTION Do not keep the starter button pressed for more than 5 seconds at a time. Release the starter button for approximately 10 seconds before pressing it again. 1. Close throttle grip, and press starter button. 27 IF ENGINE CANNOT BE STARTED RUNNING-IN During initial running-in newly machined surfaces will be in contact with each other and these surfaces will wear in quickly. Running-in maintenance at 1, 000km is designed to compensate for this initial minor wear. Timely performance of the running-in maintenance will ensure optimum service life and performance from the engine. Maximum continuous engine speed during the first 1, 000km must not exceed 5, 000 rpm. It is possible that starting will be more difficult if the vehicle has not been used for a long period of time or if the fuel hole is plugged up (starting problems even when there is sufficient fuel in the fuel tank may be an indication of a plugged fuel hole). When this happens, do not rotate the throttle grip and try the starter button a few times. If engine cannot be started or vehicle does not move, check the followings. Are you operating in accordance with the instructions given in user's manual? If starter motor is not running due to battery consumption, charge the battery. If the MIL blinks continously when the main key is on, inquiry to the daelim dealer. NOTE Do not run engine idle unreasonably. If starter button is pressed in gear position, vehicle may bring out to fall. Make sure gear is in neutral position prior to starting engine. CAUTION Running the engine beyond recommended maximum engine speed (the beginning of the tachometer red zone) can damage the engine. 28 RIDING 1. After the engine has been warmed up, the motorcycle is ready for riding. While the engine is idling, pull in the clutch lever and depress the gearshift pedal to shift into 1st (low) gear. [. . . ] Store in an area protected from freezing temperatures and direct sunlight. Cover the motorcycle (don't use plastic or other coated materials) and store in an unheated area, free of dampness with a minimum of daily temperature variation. Do not store the motorcycle in direct sunlight. 50 SAFE DRIVING PREPARATION BEFORE DRIVING Performing daily inspection Putting on the protective gears (Helmet, glove, goggles, etc. ) Bringing the driver's licence Determinating the path to the desired destination 51 DRIVING METHOD 52 PRECAUTION WHEN DRIVING Secure the safe distance. Do not drive excessively long distance and take enough break. If any abnormality is found, stop driving and contact service center to inspect the vehicle. [. . . ]