User manual DIRT DEVIL SPIDER 2.0 M612

[. . . ] This does not apply to batteries or rechargeable batteries which have become faulty or have a reduced service life as a result of normal wear or improper handling. We reserve the right to make changes to technical and design specifications in the interest of continuous product improvement. © Royal Appliance International GmbH 14 EN „„ Children must not perform cleaning or user maintenance tasks without supervision. SAFETY INSTRUCTIONS About the operating manual Read this operating manual completely before using the appliance. [. . . ] 1  : 1  Charging indicator light; 2  Cleaning indicator; 3  Battery indicator; 4  Recessed grip to release dust bin compartment cover; 5  Mains adapter; 6  Mains adapter cord; 7  Mains adapter plug; 8  Battery compartment cover; 9  Battery pack; 10  Battery compartment; 11  Rubber-coated drive wheels; 12 Slide controller to set sensitivity of antifall sensors; 13  Round brooms; 14  Mount for round brooms; 15  Suction inlet; 16  Charging socket on appliance; 17  ON/OFF switch Fig. 7 : 1  Dust bin compartment cover; 2  Dust bin cover; 3  Filter; 4  Dust bin; 5  Recessed grip to release dust bin compartment cover; 6  Dust bin compartment The following in particular is prohibited: Preparatory work „„ Vacuuming: –– People, animals, plants or items of clothing on the body ➔ High risk of injury! –– Hot ash , burning cigarettes , matches and highly flammable substances ➔ Risk of fire!„„ Carrying out repairs yourself ➔ Risk of injury and loss of entitlement to free replacement!1  : 1 Charging indicator light • Flashes blue, when the battery pack is charging • Lights up with constant blue light when the battery pack is fully charged • Flashes alternately with battery indicator during operation 2 Cleaning indicator • Lights up red when dust bin must be emptied 3  Battery indicator • Lights up red when battery pack must be charged or appliance has no contact to floor • Flashes alternately with charging indicator light during operation Unpacking and preparing 1 Check that the unpackaged contents are complete (Fig. If you notice any transport damage or if anything is missing, contact your dealer immediately. 2 When using the appliance on hard floors, attach the round brooms one after the other as shown (Fig. If you want to remove the round brooms, grab the bristles and pull the round brooms away from the appliance (Fig. NOTE: EN Inserting the battery pack Ensure that the sticker with the words “This side up” is facing up and the contacts in the battery compartment are able to engage in the apertures in the insulation of the battery pack. For this purpose, let the battery pack first slide into the battery compartment on the side with the contacts (Fig. 6 ) and then press the battery pack into the battery compartment on the other side (Fig. The battery pack must rest evenly on the bottom of the battery compartment. 3  Reattach the cover of the battery compartment and slide it firmly into its bracket until you hear and feel it click into place. 2  Adjust the position of the slide controllers to set the sensitivity of the anti-fall sensors at the bottom of the appliance (Fig. 1 / 12 ): • Position 0 (smallest opening) for light floors and low steps • Position 1 (Fig. 12/ B ) for light floors and slightly higher steps • Position 2 for dark floors and even higher steps • Position 3 (largest opening, Fig. 12/ A ) for dark floors and high steps Charging the battery pack !Only use the mains adapter included in the scope of supply to charge the battery pack. 2 Connect the plug of the mains adapter cable to the charging socket on the appliance (Fig. 4 After a maximum of 4 hours, the charging indicator light remains blue. If your robot constantly travels backward on dark floors, you must select position 3 (largest opening). NOTE: Cleaning floors To clean short pile carpets, remove the round brooms first. [. . . ] De/service 1  Remove and empty the dust bin > “Emptying the dust bin” on page 18. 4  Allow both e ­ lements to dry at room temperature for at least 24 hours. 5  Reinsert filter into dust bin in such a way that the plastic grid of the filter is visible. 6  Reinsert dust bin with filter into the appliance > “Inserting dust bin and filter” on page 18. [. . . ]