User manual DIRT DEVIL CENTEC JUBILE M 2828.3

[. . . ] The warranty is only valid if the date of purchase has been acknowledged by the dealer's stamp and signature on the warranty card or if a copy of the invoice or sales slip is included with the sent-in appliance. Warranty work does not extend the warranty period nor does it constitute a claim for a new warranty!In case of a warranty claim Send us the appliance with its dust container empty and a short description of the defect in printed letters. Head your accompanying letter with the notice "warranty claim". [. . . ] 5 If the appliance is defective Never use a defective appliance or operate an appliance with a defective power cord. If the power cord of this appliance is damaged it must be replaced by the manufacturers, their authorised service representative or a similarly qualified person to avoid danger. 6 Re: Disposal Dispose of the appliance in compliance with the environmental protection laws of your country. ATTENTION: Always transport or ship the appliance in its original packaging to avoid damage. NOTE: Immediately contact your dealer if you have found damage resulting from transport. Select the nozzle according to the surface to be cleaned: 4 3* 5 „ The crevice nozzle and the furniture brush are included as accessories in the scope of delivery besides the floor nozzle (Fig. 2/5): Use this to vacuum dust off objects that have sensitive surfaces. Included in the scope of delivery depending on model and features) are also: - Parquet brush (Fig. 2/2*) Its long bristles make it especially suitable for cleaning delicate surfaces (e. 2/3*) This has a rotating brush head and is most suitable for thoroughly deep cleaning of carpets. A B NOTE: When you use the long, flexible crevice nozzle, under certain circumstances the pressure inside the vacuum cleaner might drop too far thus triggering the safety valve. A whistling noise (depending on the vacuum cleaner model) and greatly reduced suction performance. In this case, depending on the vacuum cleaner model and equipment, you have to reduce the suction power or open the bypass vent until the valve no longer triggers. Push the accessory bracket onto the telescopic tube as shown, or onto the handle (Fig. Only attach the nozzles if the appliance is not connected to the power supply. 1 ATTENTION: Before vacuuming, make sure that the fitted nozzle suits the surface to be cleaned. Attach the selected nozzle to the bottom end of the telescopic tube (Fig. 5/A) of the vacuum cleaner until you hear and feel it locking into place. NOTE: Your cylinder vacuum cleaner is equipped with a safety switch to prevent overheating. Especially when vacuum-cleaning stairs make sure that you always stand on a higher level than the appliance. ATTENTION: Only use the cylinder vacuum cleaner with all filters intact, in dry condition and correctly fitted. Make sure that no objects obstruct the telescopic tube, the suction hose or other openings. [. . . ] Set the "carpet/hard floor" selector to the correct position for the type of floor, Zchapter 4. Always switch off the appliance and disconnect it from the mains before starting troubleshooting Zchapter 4. Before contacting your authorised Royal dealer, Royal service partner or appliance market or sending in the appliance, first follow the procedure in the following table to check if you can solve the problem yourself. Test the vacuum cleaner at another socket which you are sure carries current. [. . . ]