User manual DIGITAL INNOVATIONS SKIPDR

[. . . ] • To a suitable hot water connection point: your dishwasher may be supplied with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance). The water pressure must be within the values indicated in the Technical data table (see adjacent information). [. . . ] Select the wash cycle and press the HALF LOAD button: the indicator light will illuminate and the wash cycle will take place only in the upper rack. Remember to load the upper rack only, and to reduce the amount of detergent accordingly. This option is not compatible with the following wash cycles: Speed and Baby. Multi-functional tablets (Tabs) This option optimises washing and drying results. When using multi-functional tablets, press the MULTIFUNCTIONAL TABLETS button. The “Multi-functional tablets” option results in the lengthening of the wash cycle. The MULTI-FUNCTIONAL TABLETS option remains set for subsequent wash cycles if it is not deselected. The use of tablets is only recommended for models which offer the MULTI-FUNCTIONAL TABLETS option. Table of options Auto Super wash Auto Daily wash Daily A 60 Prewash Eco Speed 25’ Delicate Baby cycle A Delayed Start Yes Yes Yes Yes Yes Yes Yes Yes B C Half Tabs Load Yes Yes Yes Yes Yes No Yes No Yes Yes Yes No Yes Yes Yes No D Good Night No Yes No No Yes No No No This option is not recommended for use with wash cycles which do not specify the use of multi-functional tablets (see Table of options). * Only available in selected models. 7 Wash cycles EN For available OPTIONS please refer to the Table of options on the Start-up and use page. If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. The number and type of wash cycles and options may vary depending on the dishwasher model. Wash cycle selection instructions Wash cycle Detergent (A) = compartment A (B) = compartment B Powder Liquid Tablets Wash cycles which include drying Options Wash cycle duration (tolerance ±10%) Hrs. Min. Heavily soiled dishes and pans (not to be used for delicate items). Auto Super Wash Auto Daily wash 30 g (A) 30 ml (A) 1 (A) Yes A–B–C 2:15’ For dirty pans and dishes. Pre-wash for dishes while awaiting completion of the load with the dishes from the next meal. Environmentally-friendly wash cycle with low energy consumption levels. (Run cycle immediately after use) (2 plates + 2 glasses + 4 pieces of cutlery + 1 saucepan + 1 small frying pan). - Press the P button repeatedly until the desired hardness level has been reached (1-2-3-4-5* see Water hardness table). Hardness level 1 (1st wash cycle indicator light flashes) In order to achieve the best possible results using a wash cycle, make sure that the dispenser is never empty. Refined salt removes limescale from the water, thus avoiding the formation of deposits on crockery. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: • When the green float* cannot be seen by simply looking at the cap of the salt dispenser. • When the LOW SALT* indicator light on the control panel is illuminated; 1. Position the funnel* (see figure) and fill the salt container right up to its edge (this should hold approximately 1 kg); it is not unusual for a little water to leak out. Remove the funnel* and wipe any salt residue away from the opening; rinse the cap under running water and then screw it on, the head facing downwards so as to let the water flow out of the four cracks which are arranged in a star shape on the lower part of the cap. (the container cap with the green float*) It is advisable to perform this procedure every time you add salt to the container. Make sure the cap is screwed on tightly, so that no detergent can get into the container during the wash cycle (this could damage the water softener beyond repair). When necessary, measure out the salt before a wash cycle so that any saline solution which has leaked out of the salt dispenser is removed. The use of refined salt is not necessary for Eco wash cycle. * Only available in selected models. 9 Care and maintenance EN • Turn off the water tap after every wash cycle to avoid leaks. [. . . ] • The level of the refined salt is low or the dosage setting is not suited to t h e h a r d n e s s o f t h e wa t e r (s e e R i n s e a i d a n d s a l t ). • T h e l i d o n t h e s a l t d i s p e n s e r i s n o t c l o s e d p ro p e rl y. • T h e ri n s e a i d h a s b e e n u s e d u p o r t h e d o s a g e i s t o o l o w. • T h e c ro c k e r y i s m a d e f ro m n o n -s t i c k m a t e ri a l . [. . . ]