User manual DICOTA PHASOR

[. . . ] Caution: To use this product properly, please read the user's guide before installation. Please adhere to the following warnings and safety instructions to prevent injury: 1. [. . . ] Caution: Change or modifications not expressly approved by the manufacturer responsible for compliance, could void the user's authority to operate the equipment. Installing the batteries Step1: Press the button on the Phasor and pull the battery cover backward. Install the receiver It needs to be plugged into your computer or Notebook via the USB port. But if some interference happens, then you should please setup the connection RF Channel. If the cursor does NOT move after 30 seconds, please do the step above. Caution: If you have completed the connection successfully, the LED on the receiver will flash several times. If the RF Channel is not connected properly, please reset RF Channel again by following the above steps. Recharging: Please plug the USB cable into the front of the mouse and in your computer or Notebook by USB port. It is recommended that the batteries are charged for at least 12 hours before first use, to ensure a better performance of the rechargeables. After 12 hours Phasor is ready for normal use and you can enjoy the full performance capacity. Using your Phasor How to use the wheel Your mouse has a wheel that functions both as a wheel for Windows scrolling and also as a middle button. Mouse does not work upon installation Try one or more of the following: · Make sure you have installed the batteries correctly. [. . . ] Customer Service: If you encounter any problem with your Phasor, please contact our local subsidiary, partner or dealer, or send us your inquiry to info@dicota. All the products and software mentioned above are registered trademarks of their respective owners. [. . . ]