User manual DICOTA LINK

[. . . ] Exe" into the dialog box (NOTE: "D:\" represents the drive letter assigned to the optical drive you are using. If D is not the letter assigned to your optical drive, replace D with the appropriate drive letter), then click "OK". [. . . ] FCC and CE Compliance Statement These limits are designed to provide reasonable protection against frequency interference in residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed or used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in television reception, which can be determined by turning the equipment off and on. The user is encouraged to try and correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected to. The Federal Communications Commission warns the user that changes or modifications to the unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Disclaimer Information in this document is subject to change without notice. The manufacturer does not make any representations or warranties (implied or otherwise) regarding the accuracy and completeness of this document and shall in no event be liable for any loss of profit or any commercial damage, including but not limited to special, incidental, consequential, or other damage. No part of this document may be reproduced or transmitted in any form by any means, electronic or mechanical, including photocopying, recording or information recording and retrieval systems without the express written permission of the manufacturer. Customer Service: If you encounter any problem with your Link, please contact our local subsidiary, partner or dealer, or send us your inquiry to info@dicota. All the products and software mentioned above are registered trademarks of their respective owners. This symbol (crossed out bin wheelie symbol according to WEEE Annex IV) indicates separate collection of waste electrical and electronic equipment in the EU countries. Please use the return and collection systems available in your country for the disposal of this product. [. . . ] This symbol (crossed out bin wheelie symbol according to WEEE Annex IV) indicates separate collection of waste electrical and electronic equipment in the EU countries. Please use the return and collection systems available in your country for the disposal of this product. [. . . ]