User manual DICOTA KANGAROO

[. . . ] However, there is no guarantee that interference will not occur in particular installation if this equipment does not cause harmful interference to radio or television, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Shielded interface cables must be used in order to comply with emission limits. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ] Tips for Battery ­ It is suggested to use AAA Alkaline batteries or AAA Ni-MH batteries for this product. ­ Please do not use different types of battery at the same time. ⭠Please follow the instructions of battery manufacturers to handle the exhausted batteries. ­ If a consumer uses batteries improperly, it is likely to cause battery broken or liquid leaked, and will result in a burn or injury. Therefore, please do not disassemble, throw into fire, or put in 100° C place or boiling water. Furthermore, please also avoid misplacing battery positive and negative into compartment or put the Alkaline batteries in a battery charger. If batteries touch rings, bracelets, or keys, it is likely to cause a short to enable batteries heated. We suggest that you take out of batteries to store in a dry and ordinary temperature place if it is not for long time use. Take the receiver out of mouse press the eject button on the bottom of the mouse. When the receiver is in the compartment of the mouse, power supply is automatically off to stop power consumption!After replacing new batteries, please reconnect your mouse and the receiver!0 doesn't work smoothly, please adjust the angle of the antenna stick on the side of the receiver to improve it!How to link your optical mouse and receiver The receiver and the mouse will be automatically connected when the receiver is plugged into the USB port of the Desktop/Notebook. Plug the USB connector of the cable into the USB port of the Desktop/Notebook, and the other end into the port in the front of the mouse. 0 implements a non-mechanical tracking engine, based on optical navigation technology, which measures changes in position by optically acquiring sequential surface images (frames) and mathematically determining the direction and magnitude of movement. As a consequence, you can use it on most kinds of tabletops, paper, and even on your pants leg. [. . . ] Please check the USB receiver is properly installed into the USB port of your Notebook. ⷠIf your mouse does not work smoothly when the receiver is installed in USB HUB, please install the receiver in the USB port of your Notebook. ⷠIf the above points can not improve your problems, please move the mouse closer to the receiver to avoid any identified interferences. [. . . ]