User manual DICOTA DATADESK 90

[. . . ] Dear Customer, We would like to thank you that you bought a DICOTA product. Before you use your DataDesk 80/90 for the first time please read the following user manual thoroughly. [. . . ] The DataDesk 80/90 should always be opened during the recharging procedure of the equipment!(1) (2) (3) (4) (5) (6) (7) (8) Fit for your printer (Canon i80/iP90) Cable routing help Stow-away pocket for CD-ROM, 3, 5" FDD, etc. Stow-away pocket for printed paper Stow-away pocket for Notebook power supply with plug for a Euro 8-socket (with / without ground wire) Stow-away pocket for printer power supply with plug for a Euro 8-socket (with / without ground wire) Notebook strap Flap lid (not seen in Fig. Installation of your mobile printer Installation of your mobile printer open your DataDesk 80/90. 1) 2) 3) 4) Remove the flap lid from the bottom part of the case, which functions as your Notebook workspace. Place the printer power supply in the front pocket of the bottom part of the case (Fig. Now connect the Euro 8 plug with the 220 V socket of the power supply (Fig. Route the printer power cable through the designated groove (under the flap lid) and sideways past the printer (Fig. Pay attention to a clean cable routing to prevent damaging the printer cable (e. Installation of your Notebook Installation of your Notebook 1) 2) 3) Place the Notebook power supply in the rear pocket of the bottom part of the case. Route the low voltage power supply outlet cable beneath the flap lid through the designated groove, so that the cable can not be damaged when the lid is closed!Now you have two options of fastening your Notebook: 1) Either you use the four synthetic corners which are provided within the scope of supply and fasten them by using the eight self-adhesive 3M Velcro pads (Fig. [. . . ] The Notebook establishes the data connection via Bluetooth through an internal interface or a PC card module. The printer can be connected with a compact flash module, for example. [. . . ]