User manual DICOTA DATACOURIER

[. . . ] Before using your DataCourier for the first time, please read the following manual carefully. DataCourier can be used with printers currently on the market, HP DJ 450, HP DJ 460, HP Officejet H470, Canon series i80/iP90 and iP100 with or without support from the Canon Portable Kit (more printers on request! [. . . ] Remove the protective film on one side of each pair to reveal the adhesive tape beneath and press them to one corner each of your printer. 2; the white tape must still be removed, the Velcro pads can also be placed in the center of the printer) Before you mount the printer, please check the intended position on the flap since incorrect mounting can cause problems during printer operation. Mount the printer with its back side (battery side) on the closed cable box in the center and press against the lid. The further back you mount the printer the better for balance, since then the DataCourier does not tip over so easily. Installation of power supply Installation of power supply 1) 2) Take the remaining four Velcro pads and press two corresponding pairs together. Now you have two Velcro pad pairs with a protective film on each side (also see Page 3, Fig. Remove the film on one side of each pad pair and press this side to the bottom of the synthetic box. Now you can attach the synthetic box to the left inner side of the DataCourier by removing the remaining protective films. In case a Velcro pad is already attached to the inner left side, you need only remove the protective film of the corresponding side and attach it to the bottom side of the synthetic box (Fig. Storage of power supply units Storage of power supply units How to store the power supply units: The power supply units are stored on the inside of the synthetic box. Place the power supply units that belong to your printer and Notebook into the storage space (Fig. Connect the power supply units for Notebook and printer with the Euro 8 power socket (220 V) provided. [. . . ] Never close the DataCourier's lid while the printer or Notebook is being operated or the Notebook is being charged. The DataCourier should always be placed on an even surface to prevent it from tipping over while open. [. . . ]