User manual DICOTA DATACART

[. . . ] Before using your DataCart for the first time, please read the following manual carefully. DataCart can be used with printers currently on the market, HP DJ 450, HP DJ 460, HP Officejet H470, Canon series i80/iP90 and iP100 with or without support from the Canon Portable Kit (more printers on request!General information - Work environment - Operational current Scope of supply Features - Case features Installation of mobile printer Installation of power socket Storage of power supply units Connection: Notebook ­ printer 6 6 7 7 7 7 8 9 9 10 In general, please take care to operate your DataCart on a stable and skid-fast surface. [. . . ] 2; the white tape must still be removed, the Velcro pads can also be placed in the center of the printer) Before you mount the printer, please check the intended position on the flap since incorrect mounting can cause problems during printer operation. Mount the printer with its back side (battery side) on the closed cable box in the center and press against the lid. The further back you mount the printer the better for balance, since then the DataCart does not tip over so easily. If you ordered the optional printer holder , , QuickFix", proceed as follows: Insert the printer into the holder (Fig. 3 , slide in arrow direction) , mount the printer with the attached holder (depending on printer model). The DataCart has two slides on the front lid with which , , QuickFix" is connected (Fig. *Depending on the printer, there may be other , , QuickFix" holders similar to the one shown!Installation of power supply Installation of power supply 1) 2) Take the remaining four Velcro pads and press two corresponding pairs together. Now you have two Velcro pad pairs with a protective film on each side (also see Page 3, Fig. Remove the film on one side of each pad pair and press this side to the bottom of the synthetic box. Now you can attach the synthetic box to the left inner side of the DataCart by removing the remaining protective films. In case a Velcro pad is already attached to the inner left side, you need only remove the protective film of the corresponding side and attach it to the bottom side of the synthetic box (Fig. Storage of power supply units Storage of power supply units How to store the power supply units: The power supply units are stored on the inside of the synthetic box. Place the power supply units that belong to your printer and Notebook into the storage space (1). [. . . ] Before connecting the multi-plug cable to a power socket, read the manual of your Notebook and/or printer carefully. Never close the DataCart's lid while the printer or Notebook is being operated or the Notebook is being charged. The DataCart should always be placed on an even surface to prevent it from tipping over while open. [. . . ]