User manual DICOTA DATABOX ALLROUND XL TROLLEY

[. . . ] Before using your DataBox Allround XL Trolley for the first time, please read the following manual carefully. DataBox Allround XL Trolley can be used with printers currently on the market, HP DJ 450, HP DJ 460, HP Officejet H470, Canon series i80/iP90 and iP100 with or without support from the Canon Portable Kit (more printers on request!In general, please take care to operate your DataBox Allround XL Trolley on a stable and skid-fast surface. [. . . ] 3) Now you can mount the printer on the open front lid of the DataBox Allround XL Trolley by removing the protective film from the four Velcro pairs and position the printer on the lid. After mounting the printer, leave the lid open for at least twelve hours so the tape really sticks. The printer must first be shoved into the , , QuickFix" holder (Fig. The holder with the printer is then placed on the printer lid and connected to the other holders (Fig. Due to the fact that DataBox Allround XL Trolley is based on the "Floor-to-Desk" system and the Notebook is operated on a table outside the case, the installation of the printer to the Notebook must be done according to the standard installation procedure of the printer or Notebook. How to connect the Notebook with the printer is explained on the following page! the optional , , QuickFix" holder is suitable for many standard printers. *Depending on the printer, there may be other , , QuickFix" holders similar to the one shown!There are two options for connecting the Notebook to your printer: 1) Connect printer and Notebook with a USB cable. Also make sure that the USB cable is not obstructing the paper bin, thus causing paper jams!2) Data transfer between printer and Notebook via Bluetooth: (only possible if Notebook and printer are Bluetooth-compatible!Always place your Notebook in the middle compartment between the divider pads, front side down, to prevent damaging Notebooks cables and plugs. Please refer to the manuals of your printer and your Notebook before connecting the power cable to a power socket. (This cable is not included in the scope of supply of DataBox Allround XL Trolley) Never close the case lid during operation of the printer or while printer or Notebook are being charged. [. . . ] If you want to reattach the trolley system, simply proceed in the exact opposite order as when detaching the system. Mind the following steps: 1) 2) At first, you must attach the rods to the upper fastening, so that it is firmly planted in the fastening. afterwards , firmly press the spring mechanism and push it to the trolley , (Fig. [. . . ]