User manual DHI REPLACEMENT POWER SUPPLY KIT FOR RPM3 PN 402117 INSTALLATION INSTRUCTIONS

[. . . ] REPLACEMENT POWER SUPPLY KIT for RPM3 PN 402117 Installation Instructions REPLACEMENT POWER SUPPLY KIT, P/N 402117, INCLUDES: QTY 1 1 5 2 6 2 2 1 2 4 2 2 1 1 PART NO 103501 402299 100739-Z 100969-Z 102464-Z 100984-Z 101010-Z 101005-Z 101006-Z 101041-Z 103513 103514 124013 402116 DESCRIPTION Artesyn® Power Supply, +5V, +12V PROM, 68302 BIOS Mini-Micro Washer, Flat, M3 Washer, External Tooth, M3 Washer, Split Lock, M3 Screw, PHP, M3 x 6 Screw, SHC, M3 x 8 Screw, SHC, M3 x 10 Screw, SHC, M3 x 12 Tie, Cable, 3. 9" Spacer, Round, 6 MM x 6 Spacer, Round, 6 MM x 3 Bracket, Power Supply, RPM3 Cable Assembly, AC/DC, RPM3 Figure 2. Top View - Artesyn® Power Supply REMOVE AND REPLACE ARTESYN® POWER SUPPLY AND BIOS: Disconnect power cord. [. . . ] Power Supply NOTE: Installer must be properly grounded when handling BIOS IC. Figure 1. Top View - Ault Power Supply REMOVE AULT POWER SUPPLY, AND INSTALL ARTESYN® POWER SUPPLY AND BIOS: Disconnect power cord. Remove enclosure cover from unit (disconnect fan cable prior to completely removing cover). Remove and discard the stainless steel screw and lock washer that secures the AC/DC cable ground lug to the Mini Micro board. Detach the AC/DC cable from the power supply, main board and AC receptacle. The power supply is mounted in three (3) places with a stainless steel screw, a nylon screw, nylon washers and a locking plastic standoff (see Figures 4 and 5). It is not necessary to remove the plastic standoff from the old power supply Remove and discard the nylon washers located between the metal mounting tabs and the power supply. Figure 5. Right Side View Attach the new mounting bracket to side rail 2 places using the M3 x 6 pan head screw and M3 lock washer. (See figure 7) Fasten the new mounting bracket and the AC/DC Cable Assembly grounding lug to the Mini-Micro board using the M3 x 10 screw, M3 flat washer, and two M3 external tooth lock washers (see Figure 7). Fasten the new power supply to the bracket using the hardware shown in Figure 6. Figure 4. Plastic Standoff Front of Unit Remove the stainless steel screw and lock washer, and discard. Locate the tabs of the plastic standoff and squeeze them together to release the standoff from the main board. 124013 Bracket Spacer, 3 mm Long 103501 Power Supply M3 x 8 mm Screw 5. [. . . ] Cable Assembly AC Receptacle Connections RPM3 and molbox RFM are trademarks, registered and otherwise, of DH Instruments, Inc. Document 560067 050601 DH Instruments, Inc. 4765 East Beautiful Lane Phoenix AZ 85044-5318 USA Tel 602. 431. 9100 Fax 602. 431. 9559 dhi@dhinstruments. com www. dhinstruments. com [. . . ]