User manual DFI LANPARTY UT NF4 ULTRA-DR

[. . . ] System Board User's Manual 84720504 Copyright This publication contains information that is protected by copyright. No part of it may be reproduced in any form or by any means or used to make any transformation/adaptation without the prior written permission from the copyright holders. The manufacturer makes no representations or warranties with respect to the contents or use of this manual and specifically disclaims any express or implied warranties of merchantability or fitness for any particular purpose. The user will assume the entire risk of the use or the results of the use of this document. [. . . ] Your version may not be identical to this one. CPU Internal Cache and External Cache These fields speed up the memory access. The default is Enabled, which provides better performance by enabling cache. Quick Power On Self Test This field speeds up Power On Self Test (POST) whenever the system is powered on. To attain the shor test POST time, select "Enabled". 81 3 BIOS Setup First Boot Device, Second Boot Device, Third Boot Device and Boot Other Device Select the drive to boot first, second and third in the "First Boot Device" "Second Boot Device" and "Third Boot Device" fields respectively. The BIOS will boot the operating system according to the sequence of the drive selected. Set "Boot Other Device" to Enabled if you wish to boot from another device. Swap Floppy Drive When this field is enabled and the system is booting from the floppy drive, the system will boot from drive B instead of drive A. When this field is disabled and the system is booting from the floppy drive, the system will boot from drive A. Boot Up Floppy Seek When enabled, the BIOS will check whether the floppy disk drive installed is 40 or 80 tracks. Note that the BIOS cannot distinguish between 720K, 1. 2M, 1. 44M and 2. 88M drive types as they are all 80 tracks. When disabled, the BIOS will not search for the type of floppy disk drive by track number. Note that there will not be any warning message if the drive installed is 360KB. Boot Up NumLock Status This allows you to determine the default state of the numeric keypad. By default, the system boots up with NumLock on wherein the function of the numeric keypad is the number keys. When set to Off, the function of the numeric keypad is the arrow keys. 82 BIOS Setup Typematic Rate Setting Disabled Continually holding down a key on your keyboard will cause the BIOS to report that the key is down. Enabled The BIOS will not only report that the key is down, but will first wait for a moment, and, if the key is still down, it will begin to report that the key has been depressed repeatedly. For example, you would use such a feature to accelerate cursor movements with the arrow keys. You can then select the typematic rate and typematic delay in the "Typematic Rate (Chars/Sec)" and "Typematic Delay (Msec)" fields below. Typematic Rate (Chars/Sec) This field allows you to select the rate at which the keys are accelerated. Typematic Delay (Msec) This field allows you to select the delay between when the key was first depressed and when the acceleration begins. Security Option This field determines when the system will prompt for the password - everytime the system boots or only when you enter the BIOS setup. System The system will not boot and access to Setup will be denied unless the correct password is entered at the prompt. [. . . ] Inspect the cord and install a new one if necessary. Floppy Drive The computer cannot access the floppy drive. Check the path statement to make sure you are writing to the targeted drive. Use another diskette with adequate storage space. 137 B Troubleshooting Hard Drive Hard disk failure. Make sure the correct drive type for the hard disk drive has been entered in the BIOS. [. . . ]