User manual DEXAPLAN WA 620

[. . . ] C) 10 Battery connector 11 Battery compartment C 10 11 L126 Operating and safety instructions Introduction Read through these operating instructions fully and carefully. The operating instructions belong to this product and contain important points concerning bringing the appliance into service and its operation. [. . . ] Remove the battery when the appliance is not used for a long time. Functioning test !The warning signal or the melody sounds until the sensor contacts [6] have dried. Battery warning Should the appliance peep twice, one shortly after the other, approx. Place the water alarm close to a position which you would like to monitor or which is at risk of water escaping e. g. Whilst doing so make sure that the length of the connecting cable reaches the position where the alarm unit will be mounted. The height of the sensor contacts determines the water level at which an acoustic alarm is triggered. Place the alarm unit above the monitoring position so that it is not in an area endangered by water. Troubleshooting Fault Cause Remedy The appliance gives no - There is no battery connected - Connect a battery warning signal and no melody - The battery has run down - Insert a new battery even when the sensor contacts - The sensor contacts are dirty - Clean the sensor contacts come into contact with water The sound level is weak or the The battery has run down appliance bleeps approx. Position the sensor [7] at the desired position either by # laying the sensor on the surface with the sucker facing upwards # or firmly pushing the sucker [9] onto the surface. The surface here must be smooth and clean otherwise the sucker will only adhere for a short time. Stand the alarm unit [1] in the desired position or lay it down with the loud speaker [2] facing upwards. At the mounting position drill two drill holes vertically aligned, 44 mm apart. Fasten the screws supplied into the drill holes so that the screw heads project approx. Hang the alarm unit with the attachment holes [8] onto the screw heads. Maintenance and cleaning !Use a soft, dry cloth to clean the surfaces of the appliance. Disposal Do not dispose of packaging material, used batteries or products as household waste. [. . . ] To deactivate the water alarm set switch [3] to " 0 ". Service Information on dealing with problems can be found on the Internet at www. dexaplan. com. If you have any queries please contact our service office by e-mail (service@dexaplan. de) or by telephone. [. . . ]