User manual DEVILLE C07910-A

[. . . ] You are advised to read carefully and in full the information provided in order to get the best performance - and the most satisfaction - out of your DEVILLE stove. Failure to comply with the assembly, installation and operating instructions places all responsibility upon the person(s) concerned. All local, national, and European regulations must be respected when using this appliance. This insert hearth is a continuous heating appliance with an on-grid combustion, using wood, with a semi-closed combustion chamber. [. . . ] It must be directly connected to the upper outlet of the appliance and its exhaust outlet must be oriented in such a way that no bodily injury may occur (see Fig. In particular, there must be no connection tube or total or partial blockage and control units between the apparatus and the safety valve (§4. Thermal valve feed discharge : When the system is fitted with an under pressure expansion pan on a closed circuit, the appliance outlet must be fitted with a thermal relief valve with its temperature sensor. - The equipment will be joined to the smoke pipe by smoke pipes from the accepted trade to resist products of wood combustion (for example : stainless steel, enamelled sheet steel. - The pipe's diameter must not be inferior to the blast pipe's diameter of the equipment. If it is the case, the reduction must be of an immediately inferior diameter of the blast pipe and it must be located the farthest possible from the connect to the equipment. - The joining must vertically be done on a pipe leading under the ceiling. - The jointing of the joining pipe to the blast pipe of the equipment as well as to smoke pipe will be tight. As far as accommodation equipped with a CMV (Controlled Mechanical Ventilation) to the blast pipe's one and it must be located as far as possible from the joining to the equipment. It is strictly forbidden to have the wire cables go inside the chimney and the hood without them being first insulated from the fire. Radiators : For the appliance to be in proper working order, we recommend the fitting of a heat exchanger with the following power ratings : . 9 kW maximum In any case, half of the radiators should not be fitted with a thermostat. Piping: Installed in accordance with accepted trade, in compliance with the DTU 65-05 and DTU 65-10 standards only to cite both of them. We advice you not to reduce the start and return sections of the fireplace. Pressure of use and feed in water : Pressure of use: 1, 5 bar Maximal pressure: 2 bars The installation must be drained. To do this, you just have to dismantle the front panel unscrewing the 4 screws that link it up to the tub. The draining is then operated by completely unscrewing the cap located at the bottom of the left tub. Carefully check the condition of the appliance, and more especially smoke-tightness : seals, fixings, and door and frame. Check the condition of the smoke flue and the connecting pipe ; all fittings should be in good mechanical condition and be smoke-tight. Clean the extractor fan inside the hood to get rid of any dust and if necessary clear the hot air convection system. in the event of a fault , have the stove or the installation repaired by a qualified tradesman. When cleaning the machine, it is necessary to : Take apart the deflector as pictured, to clean the device. [. . . ] It is up to the Buyer to prove the reality of the noticed defects and irregularities. The Buyer must let Deville every opportunity of noticing any of those defects and irregularities in order to salve then. The Buyer must also keep the non standard supplies at the disposal of Deville, according to the instructions of the latter. EXTEND The warranty of Deville covers, except for any compensation or for damages, the free replacement or repairing of supplier the part acknowledged as being defected (except for wear and tear parts ) by its services to the exclusion of the fees for the workplace, for the removal and for the shipping. [. . . ]