User manual DEVILLE C07335 01-06

[. . . ] Fixer l'ensemble écran de mur + écran de plafond au mur en utilisant les 6 vis B, chevilles D et rondelles C, livrées dans le sachet notice et en respectant une distance de 60 mm entre le plafond et l'écran de plafond (Fig. 2 - Type and dimensional characteristics of the chimney flue to which the fireplace must beconnected. We strongly recommend that you take the time to thoroughly read and familiarize yourself with this manual in order to obtain maximum enjoyment and satisfaction from your DEVILLE fireplace. All local, national, and european regulations must be respected when using this appliance. [. . . ] In this case, the installation must be fitted with an omnipolar disconnect device having a contact opening distance greater than 3 mm. In particular, the installation must be properly grounded (green and yellow wire). 9) while maintaining a distance of 60 mm between the ceiling and the ceiling shield. Only for C07342 : locate the fixation points of the rectangular pre-cut piece (Fig. Only for C07342 : the wall screen should be fitted with the rectangular pre-cut piece (4 self-tapping screws A supplied in the instruction packet ; this operation is performed when the floor to ceiling height is greater than 2. Secure the tube cover shield to the hood shield using the self-tapping screws A supplied in the instruction packet 7 - Walls in the vicinity of the appliance Install the fireplace ready to set up at a minimum 300 mm distance from the side walls of the accommodation and from any combustible material. In order to protect the floor from heat radiation and possible falling combustible, install the unit on reflective metal shielding (or on a tiled floor) which covers the entire surface underneath and in front of the unit. The apparatus should be installed on a floor with sufficient bearing capacity. If an existing building does not meet this precondition, proper measures should be taken (for example, the installation of a load spreading plate) to enable the floor to bear the apparatus. 6b) 2 installation configurations are possible : In both cases, the ceiling shield is placed 60 mm from the ceiling. Fit the upper tube cover into the lower tube cover and adjust to dimension H. 2 holes in the upper tube cover through the 4 holes located in the upper section of the lower tube cover. assemble the 2 tube covers with the 4 selftapping screws A included in the instruction packet. Spread apart the assembly made of the 2 tube covers and fit the hood onto the fireplace. Secure this assembly onto the hood using 4 selftapping screws A, included in the instruction packet. Remove the circular knockouts from the ceiling and tube cover shields (leave the others in place) (Fig. Secure the wall + ceiling shield assembly to the wall with the 6 screws B, anchors D and nuts C included in the instruction packet while maintaining a distance of 60 mm between the ceiling and the ceiling shield (Fig. Secure the tube cover shield to the hood shield using the sheetmetal screws A supplied in the instruction packet (Fig. Special case where the chimney flue penetrates into the room at a certain height and whose dimensions allow its integration into the upper tube cover (see Fig. 1), burn a moderate fire for the first few hours, by limiting the load (one 15 cm log) and set the air intake control lever in the middle position (Fig. 14) : this enables the temperature of all chimney elements to rise progressively and ensures normal fireplace dilation. Do not join up the ready to set up to a pipe already used for other appliances. [. . . ] Loosen door closure : (Fig 23) Alternately loosen screw (2) and tighten screw (1). TERMS AND CONDITIONS Apart from the legal warranty, particularly for latent defects, Deville guarantees to deliver the furniture in case of obvious defects or non-conformity to the ordered furniture. Without prejudice to the provisions that are to be taken concerning the carrier, claims on delivery of furniture concerning the obvious defects or the non conformity, must be issued by the Buyer in writing a registered letter with confirmation of receipt to Deville company with in 5 days after noticing the defect. It is up to the Buyer to prove the reality of the noticed defects and irregularities. [. . . ]