User manual DENSION AUDIO SYSTEMS ICE LINK PLUS INSTALLATION V2

[. . . ] Applies to: Alfa Romeo, Fiat, Smart, Blaupunkt & Grundig 8 pin mini ISO Aftermarket radios Multi-application!Applies to: Alpine (MBUS), Kenwood, Panasonic, Sanyo & Sony, JVC In the case of Panasonic version attach the ying yellow wire to a +12V supply. [. . . ] Ensure that the white connector on the ice>Link harness is located in the socket nearest the centre of the radio such that the wires are nearer the centre of the radio. If the car's original connector in this location has more than 4 wires, disassemble the original connector and the ice>Link connector and swap the pins from the ice>Link connector with those in the same location in the car's connector. If there is a short black lead in the ice>Link 10 pin connector, this can be ignored. The free black lead on the ice>Link harness must be grounded to the chassis of the radio. There is typically a tab connector on the back of the radio that can be used. 8 pin mini ISO connector (blue) Simply insert the blue plug into the "C" socket (upper right) on the back of the radio. 20 pin mini ISO breakin/out connector (red) Remove the existing mini ISO plug(s) (if tted) from the back of the radio. Insert the red plug on the ice>Link harness into the mini ISO sockets on the back of the radio. 12 pin Quadlock "C" connector (white) Remove the existing quadlock plug from the back of the radio if tted and replace with the ice>Link harness. If the car's original connector in this location has more than 4 wires, disassemble the original connector and the ice>Link connector and swap the pins from the ice>Link connector with those in the same location in the car's connector. Reinsert the car's connector to the back of the radio. VW Group Connection to iPod cradle/cable car with more than 4 pins (left) car with more than 4 pins (left) Cradle Assembly Attach the cradle base to a at surface using at least two screws. We recommend the use of a damage-free mount: Cradle Place the cradle onto the cradle base. Aligh the cradle as required, then tighten the grub screw with the allen key. Navigation - 3-series E46, 5-series E39, X5 E53 only The radio tuner box in these vehicles is located in the boot. [. . . ] The free black lead on the ice>Link harness is not grounded to the chassis of the radio. Once tightened, do not force the cradle to move - you will break it!A variety of self-adhesive spacers are supplied to adjust the cradle to accept iPod models of di erent thicknesses. [. . . ]