User manual DENON TU-1500AE

[. . . ] The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc. No naked flame sources, such as lighted candles, should be placed on the apparatus. No objects filled with liquids, such as vases, shall be placed on the apparatus. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc. [. . . ] When pressed while the FM band is set, the TU-1500AE searches for stations that can be received in stereo and up to 100 stations are automatically stored at the preset channels. This lights when the strength of the reception frequency is at or above a specific level. When in the tuning mode, use this knob to raise or lower the frequency. Turn the knob clockwise to raise the frequency, counterclockwise to lower the frequency. Use the knob together with the MENU button to switch the mode setting. ( page 10 ~ 16) MEMO · Whenever the unit is in the STANDBY state, the unit is still connected to AC line voltage. Please be sure to unplug the power supply cord when you leave home for, say, a vacation. Noise may be generated if a nearby television set is on during the broadcasting reception. This function provides memory storage when the power switch is off and with the power supply cord disconnected. This lights when receiving RDS broadcasts, and flashes during the RDS search. This lights when the TU-1500AE's power is in the "on" or "standby" mode. Press this button to switch the brightness between high, medium and low, in that order. ( page 6) Connect with this terminal when a medium wave outdoor antenna is used. Press this button to switch from the standby mode to the operating mode. Also use these with the SHIFT and MEMORY buttons to use a total of 100 preset channels, A (1 ~ 10), B (1 ~ 10), . Use the SHIFT and the CHANNEL buttons during this time to designate the desired preset channel. Use this button to select the memory blocks, A (1 ~ 10), B (1 ~ 10), . In the auto tuning mode, press the TUNING button, the automatic searching begins, them stops when a station is tuned in, In the manual tuning mode, press the TUNING button, the frequency changes continuously. Use these to change the received frequency to a higher frequency (· Do not connect two FM antennas simultaneously. Even if an external AM antenna is used, do not disconnect the AM loop antenna. Make sure the AM loop antenna lead terminals do not touch metal parts of the panel. The hookup diagrams on the subsequent pages assume the use of the following optional connection cables. [. . . ] If there is no station broadcasting the designated programme type with the above operation, all the reception bands are searched. While pressing both the DIMMER and BAND buttons, plug the TU-1500AE's power supply cord into a power outlet. Check that the entire display is flashing with an interval of about 1 second, and release your fingers from the 2 buttons. When the microprocessor is reset, all the settings are restored to the factory default values. [. . . ]