User manual DENON S-A3L

[. . . ] The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, tablecloths, curtains, etc. ⷠNo naked flame sources, such as lighted candles, should be placed on the apparatus. No objects filled with liquids, such as vases, shall be placed on the apparatus. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] , directly in front of or behind the speaker system, cover the wall or door with a thick curtain to prevent resonance and reflection. The SC-A3L and SC-C3L speaker systems are of the low-leakage-flux type and can be used near televisions, but depending on the TV there may be color blotching on the picture. If this happens, turn off the TV's power, wait 15 to 30 minutes, then turn the TV's power back on. the TV's automatic degaussing circuit should reduce the blotching on the picture. The center speaker (SC-C3L) is equipped with antislip pads upon shipment from the factory. If necessary, however, also apply the included anti-slip pads (cork, approximately 2 mm thick). , stick the included anti-slip pads (cork, approximately 2 mm thick) at the four corners of the bottom surface. A3L) on a stand or bracket, M5 nuts are inserted into the bottom of the satellite speaker system (SC-A3L) at intervals of 60 mm. When mounting, following the instructions in the manual included with the speaker stand or ceiling mount bracket, and be sure to install properly and securely. 2 When the satellite speaker system (SC-A3L) is mounted on a ceiling mount bracket, it is turned upside down due to the installation angle. The Denon mark is also turned upside down, so detach the speaker net and reattach it in the opposite direction. To ensure safety, do not place any objects on top or lean objects against the speaker system. ⷠThe speaker may topple down or fall if force is applied to the sides. Be particularly careful to avoid this, as this could cause injury or other serious accidents. When installing the speaker systems on the ceiling or wall, to ensure safety, have specialists do the installation work. , to prevent people from tripping over them or otherwise pulling on them accidentally, causing the speaker systems to fall. ⷠBe sure to check for safety after installing the speaker systems. Afterwards, perform safety inspections at regular intervals to be sure there is no danger that the speaker systems will fall. Denon will accept no responsibility for damages or accidents caused by inappropriate choice of the place of installation or improper installation procedures. , due to interaction with the speaker system if there is a magnet (c) When toys or other objects using magnets are placed nearby. 2 Note that the illustrations in this instructions may differ from the actual set for explanation purposes. After reading these operating instructions, store them in a safe place. [. . . ] Peel off the sheath from the tip of the connection cord, then firmly twist the wires by hand so that they do not stick out and cause short-circuits. Loosen the terminal by turning it counterclockwise, then insert the connection cord into the hole in the speaker terminal. To "+" side on amplifier (copper colored core wire) NOTE: Make sure the core wires do not touch each other. To "­" side on amplifier (silver colored core wire) Once the connections are completely, gently pull on the speaker cords to make sure they are securely connected. [. . . ]