User manual DENON PMA-1500AE

[. . . ] We declare under our sole responsibility that this product, to which this declaration relates, is in conformity with the following standards: EN60065, EN55013, EN55020, EN61000-3-2 and EN61000-3-3. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. To completely disconnect this product from the mains, disconnect the plug from the wall socket outlet. When setting up this product, make sure that the AC outlet you are using is easily acceptable. [. . . ] PHONO: Use this position when using the record player connected to the PHONO terminals. Use the CARTRIDGE switch to switch the sensitivity to correspond to the cartridge type being used. CD: Used to listen a CD player or other component that is connected to the CD terminals. tUNER: Used to play a component such as an FM/AM tuner or a TV tuner that is connected to the TUNER terminals. DVD/AUX: Used to play a component such as a HiFi video player, TV tuner or tape deck that is connected to the DVD/AUX terminals. When the knob is set at the center position, the frequency characteristics are flattened in the range below 1000 Hz. The bass is emphasized as the knob is moved off center to the right (, ), and reduced as it is moved to the left (. When the knob is set at the center position, the frequency characteristics are flattened in the range above 1000 Hz. The treble is emphasized as the knob is moved off center to the right (, ), and reduced as it is moved to the left (. This knob is used to adjust the balance between the left and right channels. When it is set to the center position, the amplitude of the amplifier is equal on both sides. If the volume on the right side is too low, turn the knob to the right (, ). If the volume on the left side is too low, turn the knob to the left (. Use this to select the output source for recording onto a tape deck, etc. TAPE-2 1 1: (COPY) Use this to copy from the component connected to the TAPE-2/MD terminal to the component connected to the TAPE-1/CD-R terminal. TAPE-1 1 2: (COPY) Use this to copy from the component connected to the TAPE-1/CD-R terminal to the component connected to the TAPE-2/MD terminal. Use these when adding a power amplifier, a subwoofer with built-in power amplifier, etc. Connect these PRE OUT terminals to the input terminals on the additional power amplifier, subwoofer, etc. Source connected to this terminal is directly fed to the power amplifier set volume level by the component connected to this terminal. NOTE: Signals are outputted from the PRE OUT terminals even when using headphones. DIRECT terminal, volume control function of this unit does not work, so set volume level by the component connecting to this terminal. The controls (BASS, TREBLE and BALANCE ) can be used when this switch is in the OFF (£) position. [. . . ] A tape deck in which a common head is used for both recording and playback cannot be used to monitor recording. When a recording is being made using TAPE-1/CD-R, selecting TAPE1/CD-R with the INPUT SELECTOR knob will engage the RECORDING MONITOR and pemit a check of the recording condition. 2 Copy from one tape to another This amplifier has a full memory back-up system. When the power is turned on, INPUT SELECTOR knob are set to the last mode set before the power was turned off. [. . . ]