User manual DENON PMA-1315R

[. . . ] When the knob is set at the center position, the frequency characteristics are flattened in the range above 1000 Hz. The treble is emphasized as the knob is moved off center to the right ( ), and reduced as it is moved to the left ( ). ) To prevent hearing loss, do not raise the volume level excessively when using headphones. When the Volume control 7 is turned right ( ) from the center position, the adjustment range of the BASS This knob is used to control the bass quality of the sound. [. . . ] for remote control , point the wireless remote control unit towards the sensor. 13 Iput terminals (INPUTS) These are input terminals for CD players, turntables, AM/FM tuners, tape decks or other playback components. Store the removed short pin-plug in a safe place so as not to lose it. Do not plug a short pin plug into the REC (recording output) terminals. Doing so will result in a loss of sound and may damage connected equipment. This switch is used to select the input signal for the program source. PHONO: Use this position when using the record player connected to the PHONO terminals. Use the CARTRIDGE selection switch 17 to switch the sensitivity to correspond to the cartridge type being used. CD: Used to listen a compact disc player or other component that is connected to the CD terminals. DVD/AUX: Used to play a component such as a HiFi video player, TV tuner or tape deck that is connected to the DVD/AUX terminals. 15 Pre out terminals (PRE OUT) Use these when adding a power amplifier, a subwoofer with built-in power amplifier, etc. When pin plug cords are not connected, insert the included short-circuit pin plug. Ground wire, but disconnect it if humming or other noise is generated. Tape deck MD or recorder SPEAKER SYSTEM (BI-WIRING) When bi-wiring with bi-wireable speakers, connect the mid and high range terminals to SYSTEM (A) (or SYSTEM (B)), the low range terminals to SYSTEM (B) (or SYSTEM (A)). Make sure that all the connections are proper by referring to the rear panel. Check the polarity (positive and negative) of connections, and the directivity of stereo separation (right cord to right channel terminal, and left cord to left channel terminal). Turn the volume 7 and tone controls 3 , 4 and balance control 6 to yield an appropriate volume and sound quality. In the PMA-1500RII, the REC OUT signal and the speaker (headphone) signal are output via separate circuits so that knobs and switches related to the tone and volume have no effect what so ever on the sound that is recorded. Also, since the recording function is selected by the REC OUT SELECTOR switch 8 , the free program source can be played through the speakers (or headphones) even during recording. After checking the above items, turn on the power, the amplifier is set in the ready mode in a few seconds. Turn the volume 7 and tone controls 3 , 4 and balance control 6 to yield an appropriate volume and sound quality. A recording in progress can be monitored if a tape deck with three individual heads for recording and playback is used. [. . . ] Besides being able to operate the PMA-1500RII Integrated-amplifier with this Remote Control Unit, you can also operate a DENON cassette deck, MD recorder, tuner and CD player with this handy full-system Remote Control Unit. Press this button to move up or down among the preset station numbers. This button can be used to turn on the power and set standby mode of the amplifier. However, this button can be used to switch the power between the on and standby modes when and only when the power supply cord is plugged in and the main unit's power switch is set to the on/standby mode. [. . . ]