User manual DENON DP-61F

[. . . ] Retain Instructions ­ The safety and operating instructions should be retained for future reference. heed Warnings ­ All warnings on the product and in the operating instructions should be adhered to. Follow Instructions ­ All operating and use instructions should be followed. Cleaning ­ Unplug this product from the wall outlet before cleaning. [. . . ] If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Power-Cord Protection ­ Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. Outdoor Antenna Grounding ­ If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Lightning ­ For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. this will prevent damage to the product due to lightning and power-line surges. Power Lines ­ An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. Overloading ­ Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. Object and Liquid Entry ­ Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Note however, that the power is not completely turned off in this case. If you wish to completely turn the power off, disconnect the power cord from the household AC outlet. Protect the turntable too ⷠUse only a household AC power source. Make sure that the turntable is well ventilated and away from direct sunlight. ⷠTo avoid damage to the internal circuits and the external surface, keep it away from heat (stoves, etc. Avoid using spray type insecticide near the turntable it can damage the finish and might ignite suddenly. ⷠTo avoid damaging the finish, never use paint thinner or other similar chemicals to clean the turntable. If you don't plan to use the turntable for a long period of time, disconnect the power cord. ⷠTo protect the insulators, always lift the turntable when you move it. When transporting the turntable over a long distance, place it in its original box wrapped in protective wrappers. ⷠRemove all packing materials attached to the tone arm, except that on the stylus, and then open the dust cover and assemble. [. . . ] Dust cover Dust cover hinge 45 rpm adaptor and holder Equalizer amplifier switch Finger lever Size select lever STOP button Use the provided 45 rpm adaptor when playing back 17 cm records (provided the center hole is a large one). Do not touch the tone arm and platter or turn off the power during playback. ⷠThe auto return system is set to return the tone arm at a specific point on the record. There should be no problem with regular sized records, but with some record types which contain music grooves past this set point, playback will be interrupted. [. . . ]