User manual DENON DN-X300

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the product OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the product into an outlet on a circuit different from that to which the receiver is connected. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] No naked flame sources, such as lighted candles, should be placed on the apparatus. Se till att det finns möjlighet till god värmeavledning vid montering i ett rack. Unplug the power cord when not using the apparatus for long periods of time. Do not let insecticides, benzene, and thinner come in contact with the apparatus. Select any source from eight inputs (PHONO1/LINE1, You also can assign the same input to several channels for creative mixing. Please check to make sure the following items are included with the main unit in the carton: q Operating instructions . You have purchased the DENON DN-X300/DN-X900 DJ mixer from D&M HOLDINGS lnc. Matrix input assignment 8 input sources are freely assignable to each channel. Only DN-X900 : 8 input sources +4 DIGITAL sources are freely assignable to each channel. 60 MM Channel Fader (Replaceable) 60mm long-stroke channel fader for precise adjustment of the volume. Level Mater per Channel Easily visible 12- dot level meters for each channel. Pressing multiple buttons makes it possible to derive mixed sound from the selected sources. Only DN-X900 : ZONE level control Accepts either a balanced microphone with an XLR connector or a balanced microphone with 1/4" TRS mono jacks. Select when you don't assign the channel source into the Crossfader. When the fader is at its far left, only the A Mix is heard from the Outputs. as the fader is moved toward the right , the amount of B Mix is increased and the amount of A Mix is decreased. When the fader is centered, equal amounts of A and B Mixes are routed to the Outputs. When this switch is on, mixed L and R signal is outputted from the MASTER OUT. It is intended for use with a tape recorder, but is not restricted to that purpose. These 1/4" jacks provide a balanced line level output with independent front panel. These 1/4" TS mono jacks allow external processing of the program signal. When connect monaural type effect processor, use Lch input and output. [. . . ] (In the following example, startup is done with the CD player connected set to Assign A. Use the CROSSFADER CONTOUR control @9 control the cross fader startup curve. When the Crossfader @8 is slid in the opposite direction, CD player play will begin. The Crossfader may be removed without disassembly of DN-X300 and DN-X900 itself. [. . . ]