User manual DENON DN-C680

[. . . ] CD PLAYER OPERATING INSTRUCTIONS DN-C680 IMPORTANT TO SAFETY WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. LABELS (for U. S. A. model only) CERTIFICATION THIS PRODUCT COMPLIES WITH DHHS RULES 21 CFR SUBCHAPTER J APPLICABLE AT DATE OF MANUFACTURE. CAUTION: 1. Handle the power supply cord carefully Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. [. . . ] (Auto Space) · The button lights when the auto space mode is set. AUTO EDIT button · Press this button to divide the tracks on the disc into a first half (side A) and second half (side B) at the point nearest to half of the disc's total playing time. (Auto Edit) · When the A button is pressed while the auto edit mode is on, the A button lights and the number of the first track and total playing time of the first half (side A) are displayed on the character display. · When the B button is pressed while the auto edit mode is on, the B button lights and the number of the first track and total playing time of the second half (side B) are displayed on the character display. · Press the button again to cancel the auto edit mode. SCAN dial (outer side) · Turn this dial to set the manual search (fast forward or fast reverse) mode. · Turn the dial clockwise to move the playback position forward, counterclockwise to move the playback position backward. · The speed changes according to the angle at which the dial is turned. Rear Panel DIGITAL OUT (BALANCED) connector · This is an active balanced output using an XLR type connector. · Connect this connector to the balanced digital input connector on an amplifier or console. · Signal format: Selectable (See Page 24, 8) 9)) · Pin layout: 1. Hot · Applicable connector: Cannon XLR-3-31 or equivalent DIGITAL OUT (UNBALANCED) jack · This is an unbalanced output using an RCA type jack. · Connect this jack to the unbalanced digital input jack on an amplifier or console. · Signal format: Selectable (See Page 24, 8) 9)) ANALOG OUT (BALANCE) connectors · These are active balanced outputs using XLR type connectors. · Connect these connectors to the balanced analog input connectors on an amplifier or console. · Pin layout: Pin No. 1 TIME button · Press this button to switch the time display between the remaining time (REMAIN) and the elapsed time (ELAPSED). INDEX button · Press this button to set the index select mode, then use the select knob to select the index number. FADER button · Press this button to enable input of the fader input signals connected to the "PARALLEL REMOTE" connector. FINISH MODE button One of the following three finish modes can be selected: · Press the STOP button to light the button and set the finish mode to the stop mode. · Press the NEXT button to light the button and set the finish mode to the next mode. · Press the RECUE button to light the button and set the finish mode to the recue mode. SEARCH dial (inner side) · Turn this dial to set the manual search mode. · Turn the dial clockwise to move the playback position forward, counterclockwise to move the playback position backward. The playback position can be moved anywhere between the beginning of the first track and the end of the last track. 2 3 U. S. A. [. . . ] The initial setting is "OFF". ) : : Play skip tracks on CDR discs. (The frames are displayed in the manual search, standby, pause and end monitor modes. ) : : Inhibit all operations other than the PLAY/ PAUSE, TIME and PLAY MODE buttons during playback. : Inhibit operation of all panel switches other than those used for presetting operations. : Output index 2 tally signal to remote pin (17). : Output index 3 tally signal to remote pin (17). : Clear the presettings (set to the initial factory values). [. . . ]