User manual DENON DCD-F101

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Se till att det finns möjlighet till god värmeavledning vid montering i ett rack. We declare under our sole responsibility that this product, to which this declaration relates, is in conformity with the following standards: EN60065, EN55013, EN55020, EN61000-3-2 and EN61000-3-3. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc. [. . . ] The types of discs listed on the table below can be used on the DCD-F101. Usable discs Recorded signals Disc size NOTE 1: According to recording quality, some CD-R/RW cannot be played. Power on button (SYSTEM POWER ON) Press this button to switch the system power on mode. Power standby button (SYSTEM POWER STANDBY) Press this button to switch the system power standby mode. Only the discs including the marks shown on page 7 can be played on the DCD-F101. Note, however, that discs with special shapes (heartshaped discs, hexagonal discs, etc. 2 Fingerprints or dirt on the disc may lower sound and picture quality or cause breaks in playback. 2 Use a commercially available disc cleaning set or a soft cloth to wipe off fingerprints or dirt. The last track in the program is cleared each time the button is pressed. Be careful not to get fingerprints on the signal surface (the side which shines in rainbow colors). Time edit button (TIME EDIT) Press this to perform edited recording according to the length of the cassette tape. Be especially careful not to scratch discs when removing them from their cases. Do not write on the labeled (printed) side with a ballpoint pen or a pencil. Water droplets may form on the surface if the disc is moved suddenly from a cold place to a warm one. If the disc is not properly loaded, it may slip out of the guide and block the disc tray. Be careful not to let your fingers get caught when the disc tray is closing. Do not load cracked or warped discs or discs that have been fixed with adhesive, etc. Do not use discs on which the adhesive part of cellophane tape or glue used to attach the label is exposed, or discs with traces of tape or labels that have been peeled off. Keep discs in their cases to protect them from dust, scratches and warping. Figure 1 Being careful not to touch the disc's data surface, set the disc in the disc tray with the labeled side facing up. When the disc holder closes, the total number of tracks on the disc and the total playing time appear on the display, and the numbers on the music calendar light up to the number of tracks on the disc. When the play button is pressed after a disc is set on the disc tray, the disc holder closes and playback starts. [. . . ] 2 The editing function is set from system remote control unit (RC-927) included with the receiver (DRA-F101). The display switches between sides A and B each time the button is pressed. Example: Recording a disc containing 18 tracks with a playing time of 56 minutes onto a 60-minute cassette tape Turn on the power of the receiver. Load the cassette tape onto which you want to record into the cassette deck, then close the cassette holder. [. . . ]