User manual DENON AVR-1306

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. DECLARATION OF CONFORMITY We declare under our sole responsibility that this product, to which this declaration relates, is in conformity with the following standards: EN60065, EN55013, EN55020, EN61000-3-2 and EN61000-3-3. Se till att det finns möjlighet till god värmeavledning vid montering i ett rack. Unplug the power cord when not using the apparatus for long periods of time. [. . . ] Use this switch to monitor a video source other than the audio source. The AVR-1306 has an AUTO signal detection mode that automatically identifies the type of incoming audio signals, but is also equipped with a manual mode that can be switched according to the type of input audio signals. Input mode when playing DTS sources: Noise will be output if DTS-compatible CDs or LDs are played in the "ANALOG" or "PCM" mode. When playing DTS-compatible sources, be sure to connect the source component to the digital input terminals (OPTICAL/COAXIAL) and set the input mode to "DTS". Selecting the front speakers Press the SPEAKER A or B button to turn the corresponding speaker pair on. The front speaker A, B setting can be also be changed with the SPEAKER button on the remote control unit. Use this mode to achieve good quality 2-channel sound while watching images. In this mode, the audio signals bypass such circuits as the tone circuit and are transmitted directly, resulting in good quality sound. The "DIGITAL" indicator lights when digital signals are being input properly. If the "DIGITAL" indicator does not light, check whether the Digital In Assignment setup ( page 15) and connections are correct and whether the component's power is turned on. Press the DIRECT/STEREO button on the main unit or the DIRECT button on the remote control unit to select the DIRECT mode. 2 STEREO mode Use this mode to adjust the tone and achieve the desired sound while watching images. The "DIGITAL" indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard. Press the DIRECT/STEREO button on the main unit or the STEREO button on the remote control unit to select the STEREO mode. When the surround parameters are set using the buttons on the main unit, stop operating the buttons after completing the settings. The settings are automatically finalized and the normal display reappears after several seconds. When making parameter settings, the display will return to the regular condition several seconds after the last button was pressed and the setting will be completed. If you do want the bass and treble to be adjusted, turn off the tone defeat mode. Pro Logic II Mode: The Cinema mode is for use with stereo television shows and all programs encoded in Dolby Surround. The Music mode is recommended for stereo music and surround-encoded stereo music sources. Panorama Control: This mode extends the front stereo image to include the surround speakers for an exciting "wraparound" effect with side wall imaging. Dimension Control: This control gradually adjusts the soundfield either towards the front or towards the rear. [. . . ] DTS features a relatively higher bit rate as compared to Dolby Digital (1234 kbps for CDs and LDs, 1536 kbps for DVDs) so it operates with a relatively low compression rate. Because of this the amount of data is great, and when DTS playback is used in movie theaters, a separate CD-ROM synchronized with the film is played. With LDs and DVDs, there is of course no need for an extra disc; the pictures and sound can be recorded simultaneously on the same disc, so the discs can be handled in the same way as discs with other formats. They do not include picture data, but they offer surround playback on CD players that are equipped with digital outputs (PCM type digital output required). [. . . ]