User manual DELTA DORE RF 660 WIRELESS RECEIVER GUIDE D INSTALLATION

[. . . ] RF 660 Wireless receiver Installation and User Guide Warnings · Carefully read these instructions prior to installation. · The unit must be installed in compliance with currently applicable standards. [. . . ] The required temperature is set on the thermostat of each heat emitter. , Room temperature 19°C 18°C 17°C Pilot Wire principle: Programmer Heat emitters Comfort Médio Modérato Pilot Wire orders Economy 16°C Absence Receiver Pilot Wire (e. g. Wireless/Pilot Wire) 7°C or 8°C No Heating Off *2701878_Rev. 1* Connection Mounting and connections Switch off the mains power supply to your electrical meter (general circuit breaker) before any intervention. - Fit the receiver behind the convector, letting the radio antenna project from it. Important: the operating temperature of the receiver must not exceed 50°C. You must not install the receiver to near the hottest parts of the convector. 1 2 N L Pilot wire Blue Brown Black http://pro. deltadore. com DELTA DORE TALCO - Bonnemain - F-35270 COMBOURG - FRANCE E-mail: deltadore@deltadore. com 3 4 blue wire brown wire black wire N L Position behind the convector You must let the radio antenna project from the top of the convector to obtain a correct radio transmission. Antenna radio Convector No Screw-mounting Mounted on a wall using the screws and pegs supplied. Device complying with the requirements of the directives: R&TTE 1999/5/CE Because of changes in standards and equipment, the characteristics given in the text and the illustrations in this document are not binding unless confirmed by Delta Dore. Mounting by double-sided adhesive tape Secure to the wall by using the double-sided adhesive tape supplied. Ensure that the surface on which the tape is applied is thoroughly clean before attaching the tape. Association Associating the receiver with a transmitter On the receiver: Press the button for about 3 seconds until the two LEDs flash: the receiver is in association mode. On the transmitter: Depending on the transmitter, go to radio configuration mode. On the receiver: The two LEDs stop flashing to confirm the association operation. Home automation functions The product is compatible with the following X2D transmitters: - door/window magnetic contacts (heating goes to frost protection mode when a window is opened), - telephone transmitters (remote control of the heating), - on/off, raise/lower and scenario home automation remote controls (in automatic mode: the product sets up a local override in Comfort or in Economy mode), - wireless alarm control units (in automatic mode: switch to economy mode when the alarm is activated and return to comfort mode when the alarm is deactivated). To associate the transmitters, refer to the "Association" section. Operation The LEDs show you the current mode: or . Removing all the receiver associations Press and hold the button. Release the button. The médio (Comfort -1°C) and modérato (Comfort -2°C) modes are displayed by the The LEDS are off for the Frost Protection and Off modes. The heat emitter must be in the automatic setting for the programmer to be able to control it. Override You can locally interrupt the current mode up to the next change of order sent by the control unit. The change is shown as follows: - the LED flashes during an override of the Comfort mode to the Eco mode, - the LED flashes during an override of the Eco mode to the Comfort mode. Note: the association remains in the event of a power failure. Important: an override is cancelled if there is a power failure. Turning off the LEDs You can keep the LEDs turned off permanently so that they do not annoy you during the night: - press and hold the receiver button for about 10 seconds, - all the LEDs switch off while letting the product function normally. [. . . ] · You have subscribed to the tempo tariff and you are in an economy period. You must start by removing all the radio associations. · · · · · · [. . . ]